Notifications
Clear all
Mike Jeffries
Mike Jeffries
Group: Registered
Joined: 2020/05/20
Active Member
1
@gordon-w Thank you - i just pulled out the spare kit bag an...

In forum Hardware, firmware and software help

1 year ago
Z-Axis is squeaking at the lower end - what can i use to lub...

In forum Hardware, firmware and software help

1 year ago
@neophyl Thanks!!

In forum PrusaSlicer

1 year ago
Prusa Slicer lags when dragging it on my screen

In forum PrusaSlicer

1 year ago
@darcshadow I never change that. Its usually set at 2. I'll ...

In forum Hardware, firmware and software help

1 year ago
I actually only saw .20... I manually changed some prints to...

In forum Hardware, firmware and software help

1 year ago
@crawlerin Thanks for your answer. I saw that i have an 0.4m...

In forum Hardware, firmware and software help

1 year ago
@crawlerin I wasnt aware of this. I didnt know how large i c...

In forum Hardware, firmware and software help

1 year ago
What settings can I change to print faster without affecting...

In forum Hardware, firmware and software help

1 year ago
@oxygen I did look - its TEXTURED - not smooth.

In forum General discussion, announcements and releases

2 years ago
@oxygen I was looking on aliexpress and alibaba but i dont t...

In forum General discussion, announcements and releases

2 years ago
Spring Steel Sheet With Smooth PEI for Prusa Mini - any repl...

In forum General discussion, announcements and releases

2 years ago
@joantabb I actually literally found out about it 2 hours ag...

In forum General discussion, announcements and releases

2 years ago
Overture PLA 1.75mm

In forum General discussion, announcements and releases

2 years ago
@joantabb Correct -0.85

In forum Hardware, firmware and software help

2 years ago
@karl-herbert I may have figured it out. Its just that the c...

In forum Hardware, firmware and software help

2 years ago
First Layer issues

In forum Hardware, firmware and software help

2 years ago
Share: