Activity
 
Notifications
Clear all
JLTX
JLTX
Group: Registered
Joined: 2017/01/30
Reputable Member
5
Good news, it is not the Einsy board or driver. I swapped c...

In forum Hardware, firmware and software help

7 months ago
@dan-rogers I’ve done all that except for unplugging and rep...

In forum Hardware, firmware and software help

8 months ago
@karl-herbert do you mean swap motors or swap connections to...

In forum Hardware, firmware and software help

8 months ago
Y stepper issue

In forum Hardware, firmware and software help

8 months ago
Ah, that makes sense. It is scaling down from what you set,...

In forum PrusaSlicer

8 months ago
Do you have to enable adaptive cubic infill somehow

In forum PrusaSlicer

8 months ago
@swiss_cheese good eye. It is a magnetic fender I designed ...

In forum How do I print this? (Printing help)

8 months ago
OK, the slots worked! no more warping. Thanks for the help...

In forum How do I print this? (Printing help)

8 months ago
The reason this print surprised me is I have had great succe...

In forum How do I print this? (Printing help)

8 months ago
The print in the enclosure was better, about half the distor...

In forum How do I print this? (Printing help)

8 months ago
@dan-rogers Yeah, I was thinking of add strain relief cuts a...

In forum How do I print this? (Printing help)

8 months ago
Maybe the photo makes it more clear. the print head was mov...

In forum How do I print this? (Printing help)

8 months ago
@dan-rogers @swiss_cheese My first instinct was warping by t...

In forum How do I print this? (Printing help)

8 months ago
@diem I can try that, but what failure mechanism are you pro...

In forum How do I print this? (Printing help)

8 months ago
need help with geometric distortion. I'm stumped

In forum How do I print this? (Printing help)

8 months ago
Is there a guide for how to get configurations from older sl...

In forum PrusaSlicer

2 years ago
That's why I bought a Prusa in the first place. Then I lear...

In forum General discussion, announcements and releases

2 years ago
@manuel-s stop asking questions and install one. 😉 Seriou...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Are you quoting e3d specs? It can go higher. Many people h...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
You are overthinking it a bit, or I should say, over prepari...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Page 1 / 23
Share: