Swishtail
Swishtail
Group: Registered
Joined: 2020/05/19
Eminent Member
2
I spent two hours disassembling and replacing the hot end as...

In forum General discussion, announcements and releases

3 months ago
@tim-m30 Thank you. Yes, I’m seeing teeth marks rather than...

In forum General discussion, announcements and releases

3 months ago
Idler Tension

In forum General discussion, announcements and releases

3 months ago
Prusa is now mailing me a replacement hot end assembly for m...

In forum General discussion, announcements and releases

3 months ago
@jrudad I asked Prusa support about the Bowden tube, as mine...

In forum General discussion, announcements and releases

3 months ago
Any recommendations on an upgrade?

In forum General discussion, announcements and releases

3 months ago
Yes, I did, though I did have great difficulty doing a cold ...

In forum General discussion, announcements and releases

3 months ago
Prusa Mini Clog

In forum General discussion, announcements and releases

3 months ago
@charles-h13 I just ordered a roll of Paramount’s Decepticon...

In forum General discussion, announcements and releases

5 months ago
@geoper2 In the US.

In forum General discussion, announcements and releases

5 months ago
Filament

In forum General discussion, announcements and releases

5 months ago
@thomas-b13 Thank you for posting this. I'm still waiting o...

In forum Assembly and first prints troubleshooting

6 months ago
@robee Which sock did you use on the Mini?

In forum General discussion, announcements and releases

6 months ago
A $15 upgrade cost is a no-brainer, but I'm hestitant to whe...

In forum General discussion, announcements and releases

6 months ago
@joantabb Thank you, Joan. I had read that the ball end dri...

In forum General discussion, announcements and releases

6 months ago
@gordon-w When a hardware revision is made, are existing own...

In forum General discussion, announcements and releases

6 months ago
I just ordered a Mini. This thread is giving me an ulcer. ...

In forum General discussion, announcements and releases

6 months ago
I just ordered my Mini.... Hoping this gets addressed in the...

In forum Assembly and first prints troubleshooting

6 months ago
Just Ordered My Mini -- What Should I Do to Prep?

In forum General discussion, announcements and releases

6 months ago
Ugh.... I guess I’m going to order an i3 MK3S instead. My i...

In forum General discussion, announcements and releases

6 months ago
Page 1 / 2
Share:

Please Login or Register