Notifications
Clear all
Allen8355
Allen8355
Group: Registered
Joined: 2017/01/25
Trusted Member
3
I don't know, but I just installed Slicer 2.3.1 on a differe...

In forum PrusaSlicer

6 months ago
Yeah, I have that also. I BELEIVE this is not that problem....

In forum PrusaSlicer

6 months ago
No, it seems to be because the slicer is signed by Apple, bu...

In forum PrusaSlicer

6 months ago
I have the same problem. Why does it say solved? What is the...

In forum PrusaSlicer

6 months ago
You were correct. Thanks. I looked through all the Slicer s...

In forum Hardware, firmware and software help

1 year ago
Set slicer to "Original Prusa i3 MK2.5S" and I no longer get...

In forum Hardware, firmware and software help

1 year ago
Constant Request To Change Filament

In forum Hardware, firmware and software help

1 year ago
There is lots of experimenting to find out what is best. Th...

In forum Hardware, firmware and software help

2 years ago
Adhesion can be a tricky issue. I've been printing for sever...

In forum Hardware, firmware and software help

2 years ago
OK sounds like a wiring problem. If all your belts are corr...

In forum Assembly and first prints troubleshooting

2 years ago
So the "clicking" is the gears skipping on the filament. Th...

In forum General discussion, announcements and releases

2 years ago
I also did the upgrade, but afterwards had second thoughts. ...

In forum General discussion, announcements and releases

2 years ago
Real First Layer Height

In forum Assembly and first prints troubleshooting

3 years ago
With PLA, be careful with air temperature near the extruder....

In forum Hardware, firmware and software help

3 years ago
The MK2.5 sensor is different than the MK2.5S sensor, and wo...

In forum Assembly and first prints troubleshooting

3 years ago
MK2.5 Firmware on a MK2.5S?

In forum Hardware, firmware and software help

3 years ago
Yeah, it wasn't smart for Prusa to name them both the same. ...

In forum Hardware, firmware and software help

3 years ago
Could you be more specific? Which option, then which subopt...

In forum Hardware, firmware and software help

3 years ago
I received my MK2 MMU to MMU2S upgrade. I never installed my...

In forum Hardware, firmware and software help

3 years ago
Why so many filament sensor configurations?

In forum Hardware, firmware and software help

3 years ago
Page 1 / 4
Share: