Activity
 
Notifications
Clear all
Mike
Mike
Group: Registered
Joined: 2020/05/11
Trusted Member
3
I have been using a .4mm tungsten carbide nozzle from Spool3...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 week ago
I use the same boxes, but I discovered that the blue gasket ...

In forum General discussion, announcements and releases

2 months ago
Just ordered mine today.

In forum General discussion, announcements and releases

2 months ago
I too am using the 3D Upfitters enclosure sized for the I3/M...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Atomic filament nuclear nylon issue

In forum How do I print this? (Printing help)

1 year ago
@krishanuar The Midwest nozzle is 100% tungsten. The thermal...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I real think @jsw said it best in his post “From your photo,...

In forum General discussion, announcements and releases

1 year ago
@charles-h13 It may be great material, if you don’t wind gr...

In forum General discussion, announcements and releases

1 year ago
I should have looked closer at the images of this filament o...

In forum General discussion, announcements and releases

1 year ago
@charles-h13 I don’t think I’ll give up on them, but for a f...

In forum General discussion, announcements and releases

1 year ago
@3dprintingscience I love the CoPA. What I didn’t like was t...

In forum General discussion, announcements and releases

1 year ago
@peter-m26 Thank you for the advice Peter. The issue is NOT...

In forum General discussion, announcements and releases

1 year ago
@jsw Physically it's kind of like a TPU, a little soft, yet ...

In forum General discussion, announcements and releases

1 year ago
Kodak Filament

In forum General discussion, announcements and releases

1 year ago
Extrusion curls and blobs on filament load

In forum Assembly and first prints troubleshooting

1 year ago
@bobstro Just out of curiousity, why not the Pro sock? That ...

In forum Hardware, firmware and software help

1 year ago
I've learned, through experience, that particular fan cooli...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@andrewld There shouldn’t be an issue having the in use spoo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I use a 44 quart Iris tub. It sits on a shelf unit sitting n...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@matthew-c35 I haven't used IPA yet. I use dish soap and wat...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 3
Share: