Activity
 
Notifications
Clear all
Cynan
Cynan
Group: Registered
Joined: 2020/04/24
Trusted Member
3
The Mk3s+ with MMU2s is covered under the MMU2s instructions...

In forum General discussion, announcements and releases

11 months ago
The sheets are different thicknesses so remember to change s...

In forum Hardware, firmware and software help

11 months ago
I use the smooth sheet with PLA and the textured with PETG. ...

In forum Hardware, firmware and software help

11 months ago
I notice that there is no part cooling duct in your photos. ...

In forum Assembly and first prints troubleshooting

11 months ago
The guide is here, but it seems you do have to upgrade the e...

In forum General discussion, announcements and releases

11 months ago
The guide is here, but it seems you do have to upgrade the e...

In forum General discussion, announcements and releases

11 months ago
Can we get a video or some photos? Thanks.

In forum Assembly and first prints troubleshooting

11 months ago
I can’t be certain without going to check on mine, but I’m s...

In forum Assembly and first prints troubleshooting

11 months ago
If you still have issues, try cleaning the build plate with ...

In forum Assembly and first prints troubleshooting

11 months ago
I noticed on GitHub there are newer MMU2 STLs as well, marke...

In forum General discussion, announcements and releases

11 months ago
Are you sure? Checking the parts in GitHub suggests there ar...

In forum General discussion, announcements and releases

11 months ago
I suspect they’re “coming soon”. I guess either hold off or ...

In forum General discussion, announcements and releases

11 months ago
This right here. Thanks. I thought they were tight already b...

In forum Assembly and first prints troubleshooting

11 months ago
There is a Mk3s+ assembly guide. Suggest to disassemble your...

In forum Assembly and first prints troubleshooting

11 months ago
May sound stupid, but is there enough room at the back of th...

In forum Assembly and first prints troubleshooting

11 months ago
First thought is to clean the sheet with warm water and dish...

In forum Assembly and first prints troubleshooting

11 months ago
PS this was printed from Prusa’s supplied Mk3s gcode

In forum Assembly and first prints troubleshooting

11 months ago
Printed parts good enough?

In forum Assembly and first prints troubleshooting

11 months ago
Thank you both.

In forum General discussion, announcements and releases

12 months ago
My printer is in a cupboard, which I usually leave the door ...

In forum General discussion, announcements and releases

12 months ago
Page 2 / 5
Share: