Activity
 
Cynan
Cynan
Group: Registered
Joined: 2020/04/24
Trusted Member
3
One of the belts is longer than the other. Have you used the...

In forum Assembly and first prints troubleshooting

2 months ago
I purchased the MK3s+ upgrade kit and it does contain the ma...

In forum General discussion, announcements and releases

2 months ago
Probems related to the Mk2s I'd guess should go here.../p> I...

In forum General discussion, announcements and releases

2 months ago
My love Z with the textured sheet is -1.758with the SuperPIN...

In forum Assembly and first prints troubleshooting

3 months ago
There should also be a stocker on the front of the bag that ...

In forum Assembly and first prints troubleshooting

3 months ago
The calibration is still in the four corners, but it builds ...

In forum General discussion, announcements and releases

3 months ago
There is plenty of filament with the upgrade kits. I’ve prin...

In forum General discussion, announcements and releases

3 months ago
Great news! Glad I could help.

In forum Assembly and first prints troubleshooting

3 months ago
Also don't use the belt status numbers. I just learnt this m...

In forum Assembly and first prints troubleshooting

3 months ago
Something isn't right there. The screw that holds the filame...

In forum Assembly and first prints troubleshooting

3 months ago
Updated fine for me as well. Upgraded to MK3S+ parts, reset ...

In forum Hardware, firmware and software help

3 months ago
Check that the magnets are the right way around, so they pus...

In forum Hardware, firmware and software help

3 months ago
I use a FlashAir as well, however it won’t let you flash the...

In forum Hardware, firmware and software help

3 months ago
You need a computer connected, be it a laptop or Pi I'm afra...

In forum Hardware, firmware and software help

3 months ago
When I first got my printer it made what I considered to be ...

In forum Hardware, firmware and software help

3 months ago
When I unload filament and then insert more, it will auto lo...

In forum Hardware, firmware and software help

3 months ago
There shouldn't be any issues using the Gcode either. There ...

In forum How do I print this? (Printing help)

3 months ago
Mine has very slight movement, due to the bearings not being...

In forum Assembly and first prints troubleshooting

3 months ago
The instructions go from Mk3 to Mk3s+, so I think you’ll hav...

In forum Assembly and first prints troubleshooting

3 months ago
The Mk3s+ with MMU2s is covered under the MMU2s instructions...

In forum General discussion, announcements and releases

3 months ago
Page 1 / 5
Share:

Please Login or Register