Notifications
Clear all
rufflez
rufflez
Group: Registered
Joined: 2017/01/16
Estimable Member
4
Alternatives: There are plenty. Even if you want to stay awa...

In forum General discussion, announcements and releases

3 years ago
I have both sheets, I have the sticker sheet from my MK3 and...

In forum General discussion, announcements and releases

3 years ago
Copy and paste... of course. Lol I forgot the other reason ...

In forum How do I print this? (Printing help)

3 years ago
3/4 will be fine for printing. Its not mission critical to ...

In forum Assembly and first prints troubleshooting

3 years ago
I've had great results with MakerGeeks. Never have to tweak...

In forum General discussion, announcements and releases

3 years ago
You can use Chris' Pretty PETG and Pretty PLA profiles which...

In forum General discussion, announcements and releases

3 years ago
Check your power supply cables to the RAMBo board. This was...

In forum General discussion, announcements and releases

3 years ago
Pretty sure I narrowed the problem to fried conectora from t...

In forum Hardware, firmware and software help

3 years ago
There is a jumper wire connector on the MK2.5 kit that you c...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
MK2.5 preheat triggers restart

In forum Hardware, firmware and software help

3 years ago
If you're in the US and need the printed parts again, I have...

In forum How do I print this? (Printing help)

3 years ago
Ordered May 12th. I contacted support via chat and email af...

In forum General discussion, announcements and releases

3 years ago
I just used the flex profile and manually turn the knob down...

In forum How do I print this? (Printing help)

3 years ago
Is it known whether this unfixed issue has an impact on prec...

In forum General discussion, announcements and releases

4 years ago
Regarding the OP, are you saying that off the shelf filament...

In forum General discussion, announcements and releases

4 years ago
This is working well for me: I cut out the plastic insides...

In forum General discussion, announcements and releases

4 years ago
Prusaprint is really designed for the Pi Zero W... even then...

In forum General discussion, announcements and releases

4 years ago
Have you tried loosening the bolt? I don't have the issue o...

In forum Hardware, firmware and software help

4 years ago
Just had a power outage with my pi3b setup, and lost a print...

In forum General discussion, announcements and releases

4 years ago
Ninjatek also makes Cheetah which prints at normal speeds. ...

In forum General discussion, announcements and releases

4 years ago
Page 1 / 9
Share: