Notifications
Clear all
Frans Krau
Frans Krau
Group: Registered
Joined: 2017/01/12
Trusted Member
3
The Pinda is not finding the first point. Did you changed an...

In forum Hardware, firmware and software help

3 months ago
Hi RobM, what is the result when you give the following comm...

In forum General discussion, announcements and releases

3 months ago
I mounted magnets under the heatbed, made some sheets out of...

In forum General discussion, announcements and releases

5 months ago
Hi Mike, to be shure the path of the filament is ok: what ha...

In forum Hardware, firmware and software help

6 months ago
Just some thoughts: Idler space should be 13mm (see manual) ...

In forum How do I print this? (Printing help)

9 months ago
Hi Jon, Can you be more specific what and where it goes wron...

In forum Hardware, firmware and software help

11 months ago
Hi, I have upgraded two MK2s with magnets and made my own st...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Hi, I have upgraded two MK2s with magnets and made my own st...

In forum Hardware, firmware and software help

1 year ago
For me number 1 is Fusion 360, and sometimes Tinkercad, beca...

In forum General discussion, announcements and releases

1 year ago
Hi, just search in this forum for Z level adjustment first...

In forum General discussion, announcements and releases

1 year ago
Upgrade for my MK2S, and still happy

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I was quit curious about your issue, so I tested my m2 right...

In forum Hardware, firmware and software help

1 year ago
Hi Sean, The message Bed Thermal Runaway, indicades that t...

In forum Hardware, firmware and software help

1 year ago
If I place your cube on the bed of PS as presented in your s...

In forum PrusaSlicer

2 years ago
Hi Edward, I had the same issue. I found a thread in this fo...

In forum PrusaSlicer

2 years ago
I had issue like that. It was solved when I wait with printi...

In forum Hardware, firmware and software help

2 years ago
Your write: I tried to recalibrate it but I've got an error ...

In forum General discussion, announcements and releases

2 years ago
1. After a print my printhead goes +50mm up so non influence...

In forum Hardware, firmware and software help

2 years ago
I modified my MK2s with rare magnets under the PCB, removed ...

In forum Hardware, firmware and software help

2 years ago
oh jeah and the price somewhere around € 50 Frans

In forum General discussion, announcements and releases

3 years ago
Page 1 / 4
Share: