Activity
 
Notifications
Clear all
Andrew
Andrew
Group: Registered
Joined: 2020/04/08
Estimable Member
4
@mgruenloh Thanks for the info but I am really looking to se...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
You could but I wouldnt do it for long. Only until I got a n...

In forum Hardware, firmware and software help

1 year ago
It works on standard MK3s. Auto load will only work if the s...

In forum Hardware, firmware and software help

1 year ago
Enclosure Query - Filament inside or out

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Do not connect to that board in its current state. any prote...

In forum Hardware, firmware and software help

1 year ago
The corrosion looks like an acid attack from the melting pla...

In forum Hardware, firmware and software help

1 year ago
On mine the sensor was screwed down too tight. Not super tig...

In forum Hardware, firmware and software help

1 year ago
On mine the sensor was screwed down too tight. Not super tig...

In forum Hardware, firmware and software help

1 year ago
@mchughst If you scroll down the menus to Support then down ...

In forum Hardware, firmware and software help

1 year ago
Just out on YouTube, Angus (Makers Muse) has just sorted a b...

In forum Hardware, firmware and software help

1 year ago
@bobstro Sorry. I should have been a bit clearer. It wasn't ...

In forum General discussion, announcements and releases

1 year ago
FlashAir Alternative?

In forum General discussion, announcements and releases

1 year ago
@vintagepc Almost....Top tip from my painting crew....store ...

In forum General discussion, announcements and releases

1 year ago
True...ish. You can game and you can video edit....just don'...

In forum General discussion, announcements and releases

1 year ago
Dont need to loosen if the tension is reported as ok just po...

In forum Hardware, firmware and software help

1 year ago
@jeffrey-w4 If you watch the belt it will be "sliding" sidew...

In forum Hardware, firmware and software help

1 year ago
Picking the correct computer hardware...my experience

In forum General discussion, announcements and releases

1 year ago
I asked the same thing under "Does my clear Prusament hate m...

In forum How do I print this? (Printing help)

1 year ago
Hi To me the belt/pulley are not fully aligned. The symptoms...

In forum Hardware, firmware and software help

1 year ago
I hate to add to your pain but I was due to be in Calgary on...

In forum General discussion, announcements and releases

1 year ago
Page 2 / 6
Share: