Jimbo70
Jimbo70
Group: Registered
Joined: 2017/01/11
Trusted Member
3
I have been there a few times and yes it does make one feel ...

In forum General discussion, announcements and releases

4 days ago
Obviously, my first suggestion is not the answer. suggestion...

In forum General discussion, announcements and releases

2 weeks ago
Could your filament be damp or poor quality? Try a new roll ...

In forum General discussion, announcements and releases

2 weeks ago
Sell them on Ebay - someone with an older MK2 printer will b...

In forum General discussion, announcements and releases

3 weeks ago
I printed all the parts with ASA many months ago for both my...

In forum General discussion, announcements and releases

3 weeks ago
I had the same problem with my MK2.5s, it was very frustrati...

In forum How do I print this? (Printing help)

4 weeks ago
@jimmy-3 I like the concept. I also have the Vesconite beari...

In forum General discussion, announcements and releases

2 months ago
I get this error on both my MK2.5s and Mk3s if I try to prin...

In forum General discussion, announcements and releases

3 months ago
I have had similar problems. A better printer profile can he...

In forum General discussion, announcements and releases

3 months ago
this is an interesting problem - does anyone have any ideas?

In forum General discussion, announcements and releases

4 months ago
I had a similar problem. Much frustration. Removing the sens...

In forum General discussion, announcements and releases

4 months ago
@joantabb Joan - I like your posts and always find them help...

In forum Hardware, firmware and software help

5 months ago
I use a toothbrush. You can get them in various stiffness an...

In forum Hardware, firmware and software help

7 months ago
I am using the MK2.5S - it has the steel ball and the 'sens...

In forum Hardware, firmware and software help

8 months ago
Because of the suggestions made here I bought some Atomic bl...

In forum General discussion, announcements and releases

8 months ago
I finally got it to work. I used some compressed air to blow...

In forum Hardware, firmware and software help

8 months ago
@benjamin-r8 I also do not like supports and try to not use ...

In forum General discussion, announcements and releases

8 months ago
@parallax I have used a lot of eSun and it is good except fo...

In forum General discussion, announcements and releases

8 months ago
@chocki please post your stringing test

In forum General discussion, announcements and releases

9 months ago
@covertpluto3502 That worked great! No revisions needed for ...

In forum General discussion, announcements and releases

9 months ago
Page 1 / 4
Share:

Please Login or Register