Activity
 
Notifications
Clear all
Zane
Zane
Group: Registered
Joined: 2017/01/10
Eminent Member
2
A couple of thoughts on this, which can be common across man...

In forum Hardware, firmware and software help

2 months ago
Anyone had the issue crop up again after working fine when d...

In forum Assembly and first prints troubleshooting

1 year ago
Just an update, I have started to get better prints with a r...

In forum General discussion, announcements and releases

1 year ago
@malcmcm well since I'm disabling retraction the negative re...

In forum General discussion, announcements and releases

1 year ago
Anyone get smoother prints with zero to little retraction?

In forum General discussion, announcements and releases

1 year ago
I changed the ptfe and put back together again, this time ev...

In forum Hardware, firmware and software help

1 year ago
Sounds like its not put together properly, solution would be...

In forum Assembly and first prints troubleshooting

1 year ago
@atomleef Longer than what bondtech provide? The normal prus...

In forum Hardware, firmware and software help

1 year ago
Well things did improve a lot after I put the hotend back to...

In forum Hardware, firmware and software help

1 year ago
Took apart the hotend and this time inserted the PTFE provid...

In forum Hardware, firmware and software help

1 year ago
I too installed the bondtech heatbreak and it didn't fix it ...

In forum Hardware, firmware and software help

1 year ago
I bought the mini (1st batch), right away I had issues with...

In forum Hardware, firmware and software help

1 year ago
I could not install the provided ptfe from bondtech it just ...

In forum Hardware, firmware and software help

1 year ago
Bondtech heatbreak and extruder, thats all. I was getting te...

In forum Hardware, firmware and software help

1 year ago
Ah I did not realise it was just the same as an update, that...

In forum Hardware, firmware and software help

1 year ago
I suppose its difficult not to complain after hours of troub...

In forum Hardware, firmware and software help

1 year ago
I'm having the same issue with horizontal lines recently eve...

In forum Hardware, firmware and software help

1 year ago
I preferred the remaining time left also tbh, not sure why t...

In forum Hardware, firmware and software help

1 year ago
Just adding in my experience, exact same issue, z all over t...

In forum Assembly and first prints troubleshooting

1 year ago
Quick update on this if anyone is interested, and thanks for...

In forum How do I print this? (Printing help)

1 year ago
Page 1 / 2
Share: