Prusa3D Forum

MartyS

Group: Registered

Joined: 2020/03/25

Trusted Member

	Replicating and improving a little screwdriver. In forum Awesome prints (Hall Of Fame)	4 days ago
	Common mistakes when working on the nozzle and heater block ... In forum Assembly and first prints troubleshooting	5 days ago
	I did eventually get the resolution on the camera changed, s... In forum User mods - OctoPrint, enclosures, nozzles, ...	5 days ago
	Finally tied out Octoprint. In forum User mods - OctoPrint, enclosures, nozzles, ...	6 days ago
	@ditowski Back before PEI was a normal thing to print on it ... In forum General discussion, announcements and releases	1 week ago
	I've had nijaflex stick so strong to PEI that it ruined both... In forum General discussion, announcements and releases	1 week ago
	When you are in preview (layer) view the slicer shows by dif... In forum General discussion, announcements and releases	1 month ago
	I've done some printing with Ninjaflex. First tip is to use ... In forum General discussion, announcements and releases	1 month ago
	To answer your question about the benchy, you got lucky. No... In forum General discussion, announcements and releases	2 months ago
	Just realized the level of flatness needed on the bottom of ... In forum Awesome prints (Hall Of Fame)	2 months ago
	Vapor smoothing would probably mess up the flat bottom, it's... In forum Awesome prints (Hall Of Fame)	2 months ago
	I just ran into this Wordfence thing... Using the "insert m... In forum General discussion, announcements and releases	2 months ago
	Wordfence sure has made this site a pain to use... Using th... In forum Awesome prints (Hall Of Fame)	2 months ago
	@cwbullet That is an interesting thought, I have been using ... In forum Awesome prints (Hall Of Fame)	2 months ago
	Clarinet reed In forum Awesome prints (Hall Of Fame)	2 months ago
	If you mean putting a 2nd PEI sheet over a damaged one, the ... In forum Hardware, firmware and software help	2 months ago
	Ah yes, it is a difficult thing to throw away something you ... In forum Hardware, firmware and software help	2 months ago
	I guess it depends how much your own time is worth, spend ha... In forum Hardware, firmware and software help	2 months ago
	@mintprint If it's skipping in the same spot after changing ... In forum Hardware, firmware and software help	2 months ago
	Hard to imagine it's the motor, with all the work you did re... In forum Hardware, firmware and software help	2 months ago

Page 1 / 4 Next

Forum Statistics

397 Forums

36.4 K Topics

265.1 K Posts

75 Online

40.6 K Members

Latest Post: Which Mask is Better to Protect Covid-19 Virus Our newest member: JB Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts Mark all read

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed