Notifications
Clear all
julian_bauknecht
julian_bauknecht
Group: Registered
Joined: 2020/03/24
Active Member
1
The problem here I think the Mini as it was is somewhere in ...

In forum Assembly and first prints troubleshooting

1 year ago
Since there is a 26€+Shipping Upgrade Kit to Mini+with only ...

In forum Assembly and first prints troubleshooting

1 year ago
@skreelink I should mention that I don't use the original he...

In forum Assembly and first prints troubleshooting

1 year ago
idk how relevant it is, because you could install the probe ...

In forum Assembly and first prints troubleshooting

1 year ago
i also got mine exchanged by prusa. After a few months with ...

In forum Assembly and first prints troubleshooting

1 year ago
idk whats wrong with this printer, after 3 days working fine...

In forum Assembly and first prints troubleshooting

2 years ago
After i installed the upgrade Bondtech heatbreak today i did...

In forum Assembly and first prints troubleshooting

2 years ago
mhh could be possible, but i doubt that, because i tightend ...

In forum Assembly and first prints troubleshooting

2 years ago
I recived and installed the replacement Probe. Now the error...

In forum Assembly and first prints troubleshooting

2 years ago
Thats a really good question i asked myself already. I think...

In forum General discussion, announcements and releases

2 years ago
I mean the angle between X and Y: I think its a combination...

In forum General discussion, announcements and releases

2 years ago
Hey, i had so many issues accumulated with this printer that...

In forum General discussion, announcements and releases

2 years ago
I contaced support, was rly quick and helpfull this time, th...

In forum Assembly and first prints troubleshooting

2 years ago
i tried all different preheating methods, but i still have d...

In forum Assembly and first prints troubleshooting

2 years ago
I have the same issue. Only thing that helps is preheat for ...

In forum Assembly and first prints troubleshooting

2 years ago
I have the same issue that the Layerhigh differs up to 0.4mm...

In forum General discussion, announcements and releases

2 years ago
Share: