Notifications
Clear all
DanielM
DanielM
Group: Registered
Joined: 2020/03/10
Eminent Member
2
Stuck filament in extruder at filament pullout

In forum Hardware, firmware and software help

3 months ago
Hi I have used the reccommended temperature and I was able t...

In forum How do I print this? (Printing help)

1 year ago
3rd layer failed , any idea why ?

In forum Assembly and first prints troubleshooting

2 years ago
Hi Karl, Thank you for the reply, heat gun approach did not ...

In forum Assembly and first prints troubleshooting

2 years ago
Hi, Actually I pushed a little more and the heatbreak unscre...

In forum Assembly and first prints troubleshooting

2 years ago
How to clean heatbreak flooded with melted PLA

In forum Assembly and first prints troubleshooting

2 years ago
Hi Tim, And thanks for the reply, I will post a picture with...

In forum Assembly and first prints troubleshooting

2 years ago
Is this too squished ?

In forum Assembly and first prints troubleshooting

2 years ago
Hi Jody, I am glad you solved the issue and shared this with...

In forum How do I print this? (Printing help)

2 years ago
Hi, I do not know if you already did that but before trying...

In forum How do I print this? (Printing help)

2 years ago
Hi I managed to retrieve the response from Sakata Steven B...

In forum How do I print this? (Printing help)

2 years ago
Hi, Just for reference I have received from Devil Design the...

In forum How do I print this? (Printing help)

2 years ago
Hi David, Thank you for the info, I will give it a try. Be...

In forum Software (Archive)

2 years ago
Hi @Bobstro and neophyl: That is a lot of progress, a lot o...

In forum How do I print this? (Printing help)

2 years ago
@ Bobstro Thank you, I will give it a try. One of the main r...

In forum How do I print this? (Printing help)

2 years ago
Hi, Some comments below: @kennd: Thank you, this comforts me...

In forum How do I print this? (Printing help)

2 years ago
Hi, Thank you for the profiles, I was able to download them ...

In forum How do I print this? (Printing help)

2 years ago
Hi Bobstro, Thank you for the feedback but unfortunately I ...

In forum How do I print this? (Printing help)

2 years ago
Hi Bobstro, Thank you for the feedback but unfortunately I ...

In forum How do I print this? (Printing help)

2 years ago
Issues with Sakata and Devil Design filaments are clogging t...

In forum How do I print this? (Printing help)

2 years ago
Page 1 / 2
Share: