Notifications
Clear all
NickRno77
NickRno77
Group: Registered
Joined: 2020/02/23
Trusted Member
3
Does anyone have trouble when doing filament change, when lo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

8 months ago
Thanks, for me I’m guessing the Mk3s firmware will be the op...

In forum Hardware, firmware and software help

8 months ago
I’m trying to use the Mini Filament sensor for the MK3s, I c...

In forum Hardware, firmware and software help

8 months ago
Using a Prusa Mini Filament Sensor on a Mk3s

In forum Hardware, firmware and software help

8 months ago
Seems to show the prints having a matt finish, I just wash ...

In forum General discussion, announcements and releases

9 months ago
Received mine today, did a Z level test with a 70mm square. ...

In forum General discussion, announcements and releases

9 months ago
Received mine today, did a Z level test with a 70mm square. ...

In forum General discussion, announcements and releases

9 months ago
Ah, you’re in America... they are a bit funny dealing with u...

In forum General discussion, announcements and releases

9 months ago
Just checked, not in my spam.... what do you mean "next tier...

In forum General discussion, announcements and releases

9 months ago
I didn’t get an email, I only noticed because you good guys ...

In forum General discussion, announcements and releases

9 months ago
Does it say mk3s sheet on your invoice? Mine didn’t. Just pr...

In forum General discussion, announcements and releases

9 months ago
For me thinking that I ordered the mini satin sheet, doesn’t...

In forum General discussion, announcements and releases

9 months ago
I must be mad, £16 delivery to the uk,,, £55 total cost. I c...

In forum General discussion, announcements and releases

9 months ago
I hoping the BuildTak will work better with ABS and ASA... l...

In forum General discussion, announcements and releases

9 months ago
I’ve learnt to remove when the beds slightly warm and not be...

In forum General discussion, announcements and releases

9 months ago
I agree, should be smooth as silk (satin) :). The textured d...

In forum General discussion, announcements and releases

9 months ago
Impossible to purchase, I think the only people getting them...

In forum General discussion, announcements and releases

9 months ago
Will they ever restock ? I’ve been looking since they became...

In forum General discussion, announcements and releases

10 months ago
I thought this was the same as the Marlin Generator but twea...

In forum Hardware, firmware and software help

10 months ago
Marlin k-factor generator Prusa Edition Download.

In forum Hardware, firmware and software help

10 months ago
Page 1 / 3
Share: