Activity
 
Notifications
Clear all
nilok
nilok
Group: Registered
Joined: 2020/02/23
Estimable Member
4
I have a pair of MK3S's running 24/7 for at least the next f...

In forum General discussion, announcements and releases

2 years ago
@jerry-v2 Sorry, I should have been more specific. I was ref...

In forum Hardware, firmware and software help

2 years ago
Are you asking which material is easier to pierce with a nee...

In forum General discussion, announcements and releases

2 years ago
@davi-11 My shadows never went away........but like joantabb...

In forum Hardware, firmware and software help

2 years ago
Also.....I'm adding this here because even the pharmacy tech...

In forum Hardware, firmware and software help

2 years ago
I just spoke to support about this.....as I have over 30 day...

In forum Hardware, firmware and software help

2 years ago
I got confused in posters - so disregard my question about f...

In forum Hardware, firmware and software help

2 years ago
If you want the quick test, flash 3.8.1 from here: Repeat t...

In forum Hardware, firmware and software help

2 years ago
@nagjames try this:

In forum Hardware, firmware and software help

2 years ago
Here is a full set and instructions for anyone who skips to ...

In forum Assembly and first prints troubleshooting

2 years ago
Separate USB-C power supply for the Pi immediately. Remove ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
If it was me, I would start with a clean slate......as there...

In forum General discussion, announcements and releases

2 years ago
I'm in the midwest if you're close and have a decent price i...

In forum General discussion, announcements and releases

2 years ago
I just posted the links so you could see the contents of eac...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Its probably a little late now, but these should give you an...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
If I understand correctly, and you can't even spin the shaft...

In forum Hardware, firmware and software help

2 years ago
I'm going to chime in here on your Pi4 for a second. If you...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
If you have not used the included lube, then yes......I woul...

In forum Hardware, firmware and software help

2 years ago
Joan's advice is excellent, as is the included lube, but be ...

In forum Hardware, firmware and software help

2 years ago
Have you checked your grub screws and belt tensions? Did yo...

In forum Hardware, firmware and software help

2 years ago
Page 1 / 9
Share: