Activity
 
Notifications
Clear all
jsw
jsw
Group: Registered
Joined: 2020/02/20
Noble Member
3
I wonder if that's some kind of preservative. Mine did not h...

In forum Hardware, firmware and software help

10 hours ago
This was some time ago, but I am VERY sure I never had to sp...

In forum Assembly and first prints troubleshooting

1 day ago
IIAC, the defaults for all of the PrusaSlicer (and Cura) com...

In forum Assembly and first prints troubleshooting

1 day ago
Here's an example. This is the Overture so-called-transpare...

In forum General discussion, announcements and releases

2 days ago
There's really nothing stopping anyone from opening up an in...

In forum General discussion, announcements and releases

2 days ago
I have not noticed any significant difference in the appeara...

In forum General discussion, announcements and releases

2 days ago
Have you verified that the grub screws on the X and Y motor ...

In forum Assembly and first prints troubleshooting

2 days ago
I've used both the Overture and RepRapper (I think it's the ...

In forum General discussion, announcements and releases

2 days ago
First thing I checked was bed temperature under filament set...

In forum Assembly and first prints troubleshooting

2 days ago
A while back there was a report (here? might have been elsew...

In forum Hardware, firmware and software help

2 days ago
If you check the .gcode file with a text editor, you can ins...

In forum Assembly and first prints troubleshooting

2 days ago
The build plate should be very warm to the touch during the ...

In forum Assembly and first prints troubleshooting

2 days ago
What I've found when tweaking the Pinda position is that ove...

In forum Assembly and first prints troubleshooting

3 days ago
Does it heat properly? Do you have something like an infrare...

In forum Hardware, firmware and software help

3 days ago
Here in the States we have an 'implied warranty' of fitness ...

In forum Hardware, firmware and software help

3 days ago
IIRC, when I assembled mine, the Party Line from Prusa was t...

In forum Hardware, firmware and software help

4 days ago
IIRC, it was mentioned somewhere here (blog?) once and kind ...

In forum General discussion, announcements and releases

4 days ago
Ok, so I'm not on drugs then! 😉

In forum General discussion, announcements and releases

4 days ago
Survey says ... ... **DING!**

In forum General discussion, announcements and releases

5 days ago
I can say that I use the textured sheet quite regularly with...

In forum Assembly and first prints troubleshooting

5 days ago
Page 1 / 83
Share: