Notifications
Clear all
buckeyestargazer
buckeyestargazer
Group: Registered
Joined: 2020/02/18
Estimable Member
4
Prusaslicer 2.4 - turn off popup messages?

In forum PrusaSlicer

4 weeks ago
Thanks, but that's well beyond my understanding. I wouldn't...

In forum PrusaSlicer

2 months ago
Multiple printers, using Octoprint, upload sliced model to a...

In forum PrusaSlicer

2 months ago
Yes, I'm doing a two step warm up. It's not just stringing ...

In forum Hardware, firmware and software help

2 months ago
Actually I don't need to wait for it to cool before layer 2 ...

In forum Hardware, firmware and software help

2 months ago
Custom g code to adjust layer temperature

In forum Hardware, firmware and software help

2 months ago
I've done all this. The nozzle is heated to 160, then mesh ...

In forum General discussion, announcements and releases

5 months ago
I never did find a clear solution to this. One thing I've n...

In forum General discussion, announcements and releases

5 months ago
I finally had a chance to print the belt tension meter and t...

In forum Hardware, firmware and software help

7 months ago
@KarlI'll try the belt tension meter when I get a chance. @D...

In forum Hardware, firmware and software help

8 months ago
As far as I can tell everything is good. The belt and pulle...

In forum Hardware, firmware and software help

8 months ago
Y-axis crash detected....driving me nuts

In forum Hardware, firmware and software help

8 months ago
After the factory reset it says100%. I do not know what it ...

In forum Hardware, firmware and software help

8 months ago
This printer uses the new bearing clips (not the old U-bolts...

In forum Hardware, firmware and software help

8 months ago
Yes, I did. Packed with Superlube.

In forum Hardware, firmware and software help

8 months ago
I did a complete factory reset and went through the calibrat...

In forum Hardware, firmware and software help

8 months ago
No, the part is tuned to Prusament's stiffness. Your post de...

In forum Hardware, firmware and software help

8 months ago
RE: One printer slower than another?

In forum Hardware, firmware and software help

8 months ago
Actually now that I think about it, the third printer didn't...

In forum Hardware, firmware and software help

8 months ago
One printer slower than another?

In forum Hardware, firmware and software help

8 months ago
Page 1 / 8
Share: