Notifications
Clear all
SeattleDavid
SeattleDavid
Group: Registered
Joined: 2020/01/09
Estimable Member
4
PETG Print crackling after being printed, shrinking, crackin...

In forum How do I print this? (Printing help)

8 months ago
MMU2 filament goes up and down and up and down and doesn't l...

In forum General discussion, announcements and releases

10 months ago
The calibration is still in the four corners, but it builds ...

In forum General discussion, announcements and releases

10 months ago
When doing an XYZ Calibration it does not seem to be doing i...

In forum General discussion, announcements and releases

11 months ago
Instructions for Prusa Mk3S+ Upgrade

In forum General discussion, announcements and releases

11 months ago
The Prusa Mk3 advertises a 32x32 (1024 point calibration) wi...

In forum Assembly and first prints troubleshooting

11 months ago
Super PINDA 25 minute calibration

In forum Assembly and first prints troubleshooting

11 months ago
Much of where I am having problems is that I am doing very d...

In forum How do I print this? (Printing help)

1 year ago
Nobody owes me any answers, you are correct. We are all free...

In forum General discussion, announcements and releases

1 year ago
Bad bad typo on my part. Embarrassing. 0.6mm profile and 0.6...

In forum How do I print this? (Printing help)

1 year ago
@gnat A few of your responses here are rather snarky Many of...

In forum General discussion, announcements and releases

1 year ago
The filament goes all the way down into the heater assembly,...

In forum General discussion, announcements and releases

1 year ago
Any guess whether the Prusa Mini will provide the advertised...

In forum Hardware, firmware and software help

1 year ago
Anybody?

In forum General discussion, announcements and releases

1 year ago
I can certainly spend my day becoming a research associate. ...

In forum How do I print this? (Printing help)

1 year ago
You might try reading the manual. It is always wise to get ...

In forum How do I print this? (Printing help)

1 year ago
Gaps between printed traces: Why & How to eliminate?

In forum How do I print this? (Printing help)

1 year ago
I am generally quite meticulous. Here is a clean sheet with ...

In forum How do I print this? (Printing help)

1 year ago
Here is a photo showing the clear PETG bunching up on the no...

In forum How do I print this? (Printing help)

1 year ago
Is clear PETG particularly difficult?

In forum How do I print this? (Printing help)

1 year ago
Page 2 / 7
Share: