SeattleDavid
SeattleDavid
Group: Registered
Joined: 2020/01/09
Estimable Member
4
MMU2 filament goes up and down and up and down and doesn't l...

In forum General discussion, announcements and releases

1 month ago
OK, then that explains it. Thank you. I noticed that the fou...

In forum General discussion, announcements and releases

1 month ago
When doing an XYZ Calibration it does not seem to be doing i...

In forum General discussion, announcements and releases

1 month ago
Instructions for Prusa Mk3S+ Upgrade

In forum General discussion, announcements and releases

1 month ago
The Prusa Mk3 advertises a 32x32 (1024 point calibration) wi...

In forum Assembly and first prints troubleshooting

2 months ago
Super PINDA 25 minute calibration

In forum Assembly and first prints troubleshooting

2 months ago
Much of where I am having problems is that I am doing very d...

In forum How do I print this? (Printing help)

4 months ago
Nobody owes me any answers, you are correct. We are all free...

In forum General discussion, announcements and releases

4 months ago
Bad bad typo on my part. Embarrassing. 0.6mm profile and 0.6...

In forum How do I print this? (Printing help)

5 months ago
@gnat Yes, when the MMU starts reeling the filament black th...

In forum General discussion, announcements and releases

5 months ago
The filament goes all the way down into the heater assembly,...

In forum General discussion, announcements and releases

5 months ago
Any guess whether the Prusa Mini will provide the advertised...

In forum Hardware, firmware and software help

5 months ago
Anybody?

In forum General discussion, announcements and releases

5 months ago
I can certainly spend my day becoming a research associate. ...

In forum How do I print this? (Printing help)

5 months ago
It is also possible (even likely) that I did read the manual...

In forum How do I print this? (Printing help)

5 months ago
Gaps between printed traces: Why & How to eliminate?

In forum How do I print this? (Printing help)

5 months ago
I am generally quite meticulous. Here is a clean sheet with ...

In forum How do I print this? (Printing help)

5 months ago
Here is a photo showing the clear PETG bunching up on the no...

In forum How do I print this? (Printing help)

5 months ago
Is clear PETG particularly difficult?

In forum How do I print this? (Printing help)

5 months ago
I truly hate the MMU2S: "MMULoad failure"

In forum General discussion, announcements and releases

5 months ago
Page 1 / 6
Share:

Please Login or Register