Notifications
Clear all
loadinglevelone
loadinglevelone
Group: Registered
Joined: 2020/01/06
Trusted Member
3
@raymate Brand doesn't matter. It's the same for all brands....

In forum General discussion, announcements and releases

5 months ago
I just recently upgraded the firmware of my MK3s to the leat...

In forum How do I print this? (Printing help)

5 months ago
Is that a cheap IKEA table? Those are like pure resonance-ch...

In forum General discussion, announcements and releases

5 months ago
I use it whenever I change between filament types. Going fro...

In forum General discussion, announcements and releases

5 months ago
My printer have always had this clicking. Even from the very...

In forum General discussion, announcements and releases

5 months ago
Gear seems to be in the correct position. Even checked that ...

In forum General discussion, announcements and releases

5 months ago
Here I move the wheel by hand between the two endstops of th...

In forum General discussion, announcements and releases

5 months ago
I spoke too soon. Just checked again when there was no filam...

In forum General discussion, announcements and releases

5 months ago
I do get the same clicking when I move the larger gear by ha...

In forum General discussion, announcements and releases

5 months ago
No filament sensor

In forum General discussion, announcements and releases

5 months ago
www.youtube.com/watch?v=cLrA4Mj_uTM

In forum General discussion, announcements and releases

5 months ago
*stupid forum edit timeout*... should be smaller inner beari...

In forum General discussion, announcements and releases

5 months ago
That is the 100% exact same sound that I have. No question a...

In forum General discussion, announcements and releases

5 months ago
@boom I tried this. Did not solve the clicking. Gears were p...

In forum General discussion, announcements and releases

5 months ago
Nah.. don't agree. I'd rather wait a few more weeks to get p...

In forum General discussion, announcements and releases

5 months ago
The cold pull looks just perfect. But remember that this is...

In forum General discussion, announcements and releases

6 months ago
Sure, the new part work just as good as the 3D-printed ones....

In forum General discussion, announcements and releases

6 months ago
Just got a brand new prusa mini - and get the exact same cli...

In forum General discussion, announcements and releases

6 months ago
Just received my mini+ and was disappointed to find that it ...

In forum General discussion, announcements and releases

6 months ago
1. You can print one yourself. All 3D models are available f...

In forum General discussion, announcements and releases

6 months ago
Page 1 / 3
Share: