Notifications
Clear all
christopher.s
christopher.s
Group: Registered
Joined: 2015/12/03
Trusted Member
3
No, I did not contact support. The printer has been printing...

In forum Hardware, firmware and software help

9 months ago
Strange Intermittant problems after replacing my hot end

In forum Hardware, firmware and software help

10 months ago
I'm now having similar strange problems with my MK3S after r...

In forum Hardware, firmware and software help

10 months ago
Found that Amazon.com also carries the Delrin nuts for the Z...

In forum Hardware, firmware and software help

2 years ago
@karl-herbert I am going to print the x-axis parts that you ...

In forum Hardware, firmware and software help

2 years ago
@karl-herbert No, I have not tried stealth mode at all yet

In forum Hardware, firmware and software help

2 years ago
It turned out that a couple of things were going on. The fir...

In forum Hardware, firmware and software help

2 years ago
My newly built MK3S successfully printed a couple dozen hosp...

In forum Hardware, firmware and software help

2 years ago
Grrrrr. Pulled X-axis off printer in order to get the belt t...

In forum Hardware, firmware and software help

2 years ago
@karl-herbert Karl:Thank you very much for your kind reply.T...

In forum Hardware, firmware and software help

2 years ago
Firmware Bug - Crash Detect will NOT turn off completely

In forum Hardware, firmware and software help

2 years ago
How to print with PCL (Polycaprolactone) filament?

In forum How do I print this? (Printing help)

2 years ago
Interesting Project - Custom 3D printed Mask

In forum Coronavirus (COVID-19)

2 years ago
I cranked up the temperature and slightly increased the extr...

In forum How do I print this? (Printing help)

3 years ago
I also need to replace the hex spacer nuts on my MK2S. I wou...

In forum Prusa i3 kit (Archive)

4 years ago
My nephew's MK2 printer was doing the same thing, failing on...

In forum Prusa i3 kit (Archive)

4 years ago
Z height adjustment no longer working after PID Autotune?

In forum Software (Archive)

5 years ago
I updated to firmware 3.0.10, and my printer was still worki...

In forum Software (Archive)

5 years ago
Did you select 0.15 Optimal in the Print Settings and modify...

In forum Print tips (Archive)

5 years ago
How do you make those circular corner hold downs?

In forum Print tips (Archive)

5 years ago
Page 1 / 3
Share: