Activity
 
Notifications
Clear all
Syd
Syd
Group: Registered
Joined: 2019/12/22
Eminent Member
2
@stevensmith Good point, I see that it's below the octoprint...

In forum General discussion, announcements and releases

1 year ago
There is a known issue with the filament runout detection or...

In forum General discussion, announcements and releases

1 year ago
Precise data access error - seen before?

In forum Hardware, firmware and software help

1 year ago
Update 4: Solution found! After several hours of trial and e...

In forum How do I print this? (Printing help)

2 years ago
Update 3: To sanity-check, tried printing the new roll of Co...

In forum How do I print this? (Printing help)

2 years ago
Update 2: Based on the observation that the filament was ver...

In forum How do I print this? (Printing help)

2 years ago
Update: new smooth sheet arrived. First layer adhesion is g...

In forum How do I print this? (Printing help)

2 years ago
80% specifically for wood? Noticed that in PrusaSlicer it's...

In forum How do I print this? (Printing help)

2 years ago
Wood PLA first layer problems

In forum How do I print this? (Printing help)

2 years ago
@reddawg Hey, just trying to be helpful, on the "Hardware an...

In forum Hardware, firmware and software help

2 years ago
@reddawg Great! Now that you have the.stl file, you can slic...

In forum Hardware, firmware and software help

2 years ago
Was it this?

In forum Hardware, firmware and software help

2 years ago
I've had similar problems where I failed to load properly du...

In forum Hardware, firmware and software help

2 years ago
Makes me feel bad. I am averaging about 1 chat / month, and...

In forum General discussion, announcements and releases

2 years ago
I have the Mini with sensor. From my experience it doesn't ...

In forum General discussion, announcements and releases

2 years ago
I've had the same experience - a couple times I did a filame...

In forum General discussion, announcements and releases

2 years ago
Are your fans only for cooling? I’m looking to add a filtrat...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
@prus-38 I'm seeing around a 40% faster print time going fro...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Yes, I'm using and E3D .6mm with the Mini. Prusa even inclu...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
I like the blue!

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Page 1 / 2
Share: