Steve Smith
Steve Smith
Group: Registered
Joined: 2019/12/21
Trusted Member
3
@cwbulletWow hadn't seen that one before.. I will have to ch...

In forum Hardware, firmware and software help

2 days ago
This is what I have used.ptfe-tube-chamfer-and-cut-jig

In forum Hardware, firmware and software help

2 days ago
Mine finally arrived today, shipping was super slow.. approx...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 weeks ago
Would anyone know what would cause the Bondtech extruder to ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 weeks ago
Also no issue with Nozzle X.. But you could edit the .gcode ...

In forum General discussion, announcements and releases

1 month ago
I didnt think Shipping inside Germany would be that much.. ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Im in Sweden, and got the nuts and screws from a store in Ge...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
bed visualizer for sure.I use: Extra Distance Buttons, Float...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
I dont understand why Prusa decided to not use these types o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
@peter-susanTemp is 215 I am using PrusaSlicer and havent me...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
So I have the Dondtech extruder in now for about a week. and...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Yes it would be compatible.

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Nice little hack to be able to reuse the brass ferrules.. Sa...

In forum Hardware, firmware and software help

3 months ago
Have you watched this?It shows how to adjust the Z height.Yo...

In forum Assembly and first prints troubleshooting

3 months ago
The Probe is too low.. Needs to go up Put a credit card unde...

In forum Assembly and first prints troubleshooting

3 months ago
Yes can confirm this.. Biggest pain was the wrapping sleevin...

In forum General discussion, announcements and releases

3 months ago
Just recieved my Super Pinda... the install should be simple...

In forum General discussion, announcements and releases

3 months ago
Dont forget these are not just for the Mini.. I guess if you...

In forum General discussion, announcements and releases

3 months ago
They just spoke about the satin plates for the Mini, they wi...

In forum Hardware, firmware and software help

3 months ago
Dont sure if this is cheap.. but you can get the ferrules he...

In forum User mods - OctoPrint, enclosures, nozzles, ...

7 months ago
Page 1 / 3
Share:

Please Login or Register