Notifications
Clear all
oopsitsaflame
oopsitsaflame
Group: Registered
Joined: 2019/12/13
Active Member
1
Firmware feature request: offset temp for loading filament

In forum Hardware, firmware and software help

9 months ago
the purge line is just in the start-gcode at the printer set...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I hope the 180mm version fits the mini because I did order o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@geoper2 I havent found kits by 3rd party suppliers so I ord...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I had the same problem. Exchanging the PTFE inside the hoten...

In forum Assembly and first prints troubleshooting

1 year ago
alternative to original filament sensor?

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Put a Insulation below my heatbed

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Looks good although I would use a cylinder for the bearings ...

In forum Awesome prints (Hall Of Fame)

1 year ago
shameless undressing I hope its ok to post porn here 😉

In forum General discussion, announcements and releases

1 year ago
my order from the 14th shipped finally. second thing i did w...

In forum General discussion, announcements and releases

1 year ago
As a 14th orderer I have to say I'm not angry that Prusa has...

In forum General discussion, announcements and releases

2 years ago
😲 Theres a shipped order from the 14th on the sheet! I still...

In forum General discussion, announcements and releases

2 years ago
could the black foil be from the shipping company after they...

In forum General discussion, announcements and releases

2 years ago
if resistance goes up on those thermistors adding a box with...

In forum Hardware, firmware and software help

2 years ago
@phr0ze most probably the limit is not accessible via gcode/...

In forum Hardware, firmware and software help

2 years ago
Thanks, the stuva looks interesting but we already have our ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
to answer my own question, it wont fit. Just watched prusas ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
IKEA Besta will the mini fit?

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Share: