Activity
 
Notifications
Clear all
hawai
hawai
Group: Registered
Joined: 2019/12/04
Estimable Member
4
Hi Chuck, I'm unhappy with the obvious stranding and the f...

In forum Assembly and first prints troubleshooting

2 weeks ago
Kia ora calibration helpers, unhappy me again 🙂 I got mys...

In forum Assembly and first prints troubleshooting

2 weeks ago
As a matter of fact I do. Does this question lead to the sug...

In forum Cura, Simplify3D, Kisslicer, ...

3 weeks ago
and after that 1/4 to 1/2 turn you need to screw in the heat...

In forum Hardware, firmware and software help

4 weeks ago
Layered between two Pizza stones (the only flat and heat res...

In forum General discussion, announcements and releases

4 weeks ago
Thanks Mr.Cheese! So off to the kitchen oven it will be. I...

In forum General discussion, announcements and releases

4 weeks ago
Annealing temperature PC Blend

In forum General discussion, announcements and releases

4 weeks ago
Thanks a lot, I think I have understood now. As I was suspec...

In forum How do I print this? (Printing help)

4 weeks ago
Odd toolpaths generated by cura

In forum Cura, Simplify3D, Kisslicer, ...

4 weeks ago
Thanks @diem, you must be an engineer. While your reply is e...

In forum How do I print this? (Printing help)

4 weeks ago
Hi there, I was about to start a new thread about PC, warpin...

In forum How do I print this? (Printing help)

1 month ago
Thanks Chuck, from the brevity of your statement I dare to c...

In forum How do I print this? (Printing help)

2 months ago
Vinyl 303 - textured or smooth sheet

In forum How do I print this? (Printing help)

2 months ago
As said before, wash the sheet! It's dirty, so wash the sh...

In forum How do I print this? (Printing help)

2 months ago
Thanks Mr. Cheese, I did indeed play around with the angle, ...

In forum How do I print this? (Printing help)

2 months ago
most likely not me, but there is always somebody who can... ...

In forum How do I print this? (Printing help)

2 months ago
Hi Alex, did I understand correctly that the mess happens ...

In forum How do I print this? (Printing help)

2 months ago
for the quick reply bob, exactly what I needed. The bridge...

In forum How do I print this? (Printing help)

2 months ago
quick and stupid question - bridge length

In forum How do I print this? (Printing help)

2 months ago
@Durhal Whow, this is definitely beyond my minimal F360 skil...

In forum Awesome prints (Hall Of Fame)

3 months ago
Page 1 / 9
Share: