Notifications
Clear all
Dronitoni
Dronitoni
Group: Registered
Joined: 2019/12/04
Eminent Member
2
just some ideas: - using the right settings in Prusaslicer i...

In forum Assembly and first prints troubleshooting

1 year ago
I started with PLA on my Mini some month ago. The adhesion t...

In forum General discussion, announcements and releases

1 year ago
Counter

In forum Hardware, firmware and software help

1 year ago
For me, the subject of the annoying beeping is finished. My...

In forum General discussion, announcements and releases

1 year ago
@tm4n I switched from PLA to PETG now, and I can say it does...

In forum General discussion, announcements and releases

1 year ago
@jweaver I support the "noise issue" on Github. It's basical...

In forum General discussion, announcements and releases

1 year ago
@hawwwran There are also some discussions/reports concerning...

In forum Hardware, firmware and software help

1 year ago
@hawwwran yes, same here. After 20 to 30 mins it getting hot...

In forum General discussion, announcements and releases

1 year ago
@crawlerin okay, makes sense to me, I will give it a try.

In forum General discussion, announcements and releases

1 year ago
@jbolene42 I tried your approach to rename the stick, but it...

In forum Hardware, firmware and software help

1 year ago
@bobstro what's the reason behind to use this paver stone? M...

In forum General discussion, announcements and releases

1 year ago
@mitcan now it also happens to me: USB is not detected. I ne...

In forum Hardware, firmware and software help

1 year ago
After some days of printing with my Mini, I can say it's abs...

In forum General discussion, announcements and releases

1 year ago
I ordered with filament sensor.

In forum General discussion, announcements and releases

1 year ago
My Mini arrived today. Unboxing, assembling, printing, prin...

In forum General discussion, announcements and releases

1 year ago
I received the shipment-notification today. 😆 Spreadsheet i...

In forum General discussion, announcements and releases

1 year ago
my delivery week is coming closer (next week). Hopefully the...

In forum General discussion, announcements and releases

2 years ago
@matteo-cristini Congratulations. 😉 Finally you made it. I n...

In forum General discussion, announcements and releases

2 years ago
@hawwwran hey you're all lucky guys. I ordered also on the 1...

In forum General discussion, announcements and releases

2 years ago
@clemens-m fyi

In forum General discussion, announcements and releases

2 years ago
Page 1 / 2
Share: