Notifications
Clear all
Buckeye Slicer
Buckeye Slicer
Group: Registered
Joined: 2019/11/26
Eminent Member
2
Not sure what the error was. Something about temp. I cleared...

In forum How do I print this? (Printing help)

4 weeks ago
Print stopped partially through 16hr print. Need solutions

In forum How do I print this? (Printing help)

4 weeks ago
How Do I Change Filament Mid Print

In forum General discussion, announcements and releases

2 months ago
First Layer advice

In forum General discussion, announcements and releases

4 months ago
For some reason I cannot upgrade my Octoprint to 1.6.1 or 1....

In forum General discussion, announcements and releases

4 months ago
Got my problem solved. Washed the sheet with a generic dolla...

In forum General discussion, announcements and releases

4 months ago
I went from -0.750 to -0.875 and gave me a perfect square, p...

In forum General discussion, announcements and releases

4 months ago
Well, I guess I celebrated a little to early. Ran an STL, ba...

In forum General discussion, announcements and releases

4 months ago
One last question, that calibration gcode that Jeff Jordan m...

In forum General discussion, announcements and releases

4 months ago
Thanks everyone for your patience with me. I really apprecia...

In forum General discussion, announcements and releases

4 months ago
no you don't see any lines underneath, and yes it pulls off...

In forum General discussion, announcements and releases

4 months ago
-0.820 100% speed  16276721447907703817871929662459.j...

In forum General discussion, announcements and releases

4 months ago
Here's 3 different pictures. One picture went up to -750 at ...

In forum General discussion, announcements and releases

4 months ago
Ok, got it to stick, so we are now at -0.660, but as you can...

In forum General discussion, announcements and releases

4 months ago
I have used both alcohol, and washed with dish soap then alc...

In forum General discussion, announcements and releases

4 months ago
somewhere between -0.080 and -0.120 Back when I was having...

In forum General discussion, announcements and releases

4 months ago
Could not get PETG to stick to sheet, or adjusted. Keeps get...

In forum General discussion, announcements and releases

4 months ago
will send pic as soon as I can get one that doesn't goop up ...

In forum General discussion, announcements and releases

4 months ago
I have printed PETG, buy after I first got it, and must have...

In forum General discussion, announcements and releases

4 months ago
Not sure about this. Went down to -080 and had filament squi...

In forum General discussion, announcements and releases

4 months ago
Page 1 / 3
Share: