Activity
 
BeeMac
BeeMac
Group: Registered
Joined: 2019/11/12
Eminent Member
2
@hu3e The SuperPinda cleared up this problem for me. The ot...

In forum Hardware, firmware and software help

2 months ago
@turro75 Thank you. That was the guidance I needed

In forum Hardware, firmware and software help

4 months ago
Y-axis bearing replacement

In forum Hardware, firmware and software help

5 months ago
@ddelgado It is an old MS DOS format for disk drives which i...

In forum Hardware, firmware and software help

8 months ago
@accounts-1 What is the tensioning gear? Is it adjusted by ...

In forum General discussion, announcements and releases

10 months ago
@accounts-1 Please describe what manually insert the filamen...

In forum General discussion, announcements and releases

11 months ago
I created a file with the single command M303 C8 D S210 and ...

In forum General discussion, announcements and releases

11 months ago
@benji How do I get the results? I run it as a print and see...

In forum General discussion, announcements and releases

11 months ago
Got one and then got Watchdog resets. The Mini doesn’t handl...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
@bobcousins I suspect it is the USB extension cord

In forum Assembly and first prints troubleshooting

1 year ago
@herbert I have and haven’t gotten a reply yet.

In forum Assembly and first prints troubleshooting

1 year ago
Used a new stick and reformatted it. Resets still happening.

In forum Assembly and first prints troubleshooting

1 year ago
New USB stick and formatted on my Mac. Short print, under an...

In forum Hardware, firmware and software help

1 year ago
@bobcousins Been there, done that. It “fixed” the problem e...

In forum Hardware, firmware and software help

1 year ago
Yep, I noticed this problem too. I have already done the PF...

In forum Hardware, firmware and software help

1 year ago
Huzzah! The Mini was delivered today! Ordered 21-Oct and shi...

In forum General discussion, announcements and releases

1 year ago
O.M.G! It shipped today! DHL estimates a Friday delivery to...

In forum General discussion, announcements and releases

1 year ago
@djarts Murphy never sleeps. 🤒 😷 😵

In forum General discussion, announcements and releases

1 year ago
@frankincell It's a bit cruel to post these pictures since m...

In forum General discussion, announcements and releases

1 year ago
@matteo-cristini I have view only, so I can’t sort which is ...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 2
Share:

Please Login or Register