mrstoned
mrstoned
Group: Registered
Joined: 2019/11/10
Estimable Member
4
I'm not sure if elefatns foot compensation could be interfer...

In forum How do I print this? (Printing help)

22 hours ago
I think you want Make Anything's file; Links to the models ...

In forum General discussion, announcements and releases

23 hours ago
@kamenb I hope so too but i think the preorders will go out ...

In forum General discussion, announcements and releases

23 hours ago
I ordered my mini+ kit on jan5 when preorder was still in ef...

In forum General discussion, announcements and releases

3 days ago
For the planters i make, i usually go with PLA, around 3 wal...

In forum General discussion, announcements and releases

7 days ago
Filled it.

In forum Coronavirus (COVID-19)

7 days ago
For whome are the survey done and where will the results be ...

In forum Coronavirus (COVID-19)

1 week ago
I use a small blowtorch a quick pass over and then i just ru...

In forum PrusaSlicer

2 weeks ago
One thing to try is to use threadpenetrating rustloosening o...

In forum General discussion, announcements and releases

2 weeks ago
That is a very elegant solution.

In forum General discussion, announcements and releases

2 weeks ago
You're welcome. Most printers can do away with 0.2-0.3mm tol...

In forum General discussion, announcements and releases

2 weeks ago
An honest answer is that It depends. On material used, print...

In forum General discussion, announcements and releases

2 weeks ago
The only difference i can see that might be critical, is the...

In forum Hardware, firmware and software help

3 weeks ago
@cwbullet I found this on their github; Hope it helps.

In forum Hardware, firmware and software help

3 weeks ago
I just thought i share my insomnia thoughts; Printed dimensi...

In forum Assembly and first prints troubleshooting

3 weeks ago
That's good. I'm planning on exchanging my qq-s for the min...

In forum General discussion, announcements and releases

3 weeks ago
I wonder if prusa have any mini's running in their printfarm...

In forum General discussion, announcements and releases

4 weeks ago
Thanks. I was only asking for my own interest. When i worked...

In forum Awesome prints (Hall Of Fame)

1 month ago
A suggestion for the filament sensor is to mount it on a sea...

In forum General discussion, announcements and releases

1 month ago
I have a question for sterilization/cleaning; Could parts be...

In forum Awesome prints (Hall Of Fame)

1 month ago
Page 1 / 7
Share:

Please Login or Register