Notifications
Clear all
mrstoned
mrstoned
Group: Registered
Joined: 2019/11/10
Estimable Member
4
I cant offer any advice on support itself, but if you have c...

In forum PrusaSlicer

1 week ago
My guess will be that the thin line is too narrow to print n...

In forum Hardware, firmware and software help

3 weeks ago
I would go another route, and punch a hole thru and use an M...

In forum General discussion, announcements and releases

3 weeks ago
It's been along time since i seen magice smoke... Perhaps ti...

In forum Hardware, firmware and software help

4 weeks ago
So then it would, in theory, be possible to use the same bud...

In forum Hardware, firmware and software help

4 weeks ago
Are the Z-motors indipendent of eachother?

In forum Hardware, firmware and software help

4 weeks ago
It may be that the layers below doesn't have time to solidif...

In forum How do I print this? (Printing help)

4 weeks ago
It have gone thru about 4kg PLA, 3kg PETG and about 1kg of A...

In forum Hardware, firmware and software help

1 month ago
Another way, altho this could also be destructive, is to use...

In forum Hardware, firmware and software help

1 month ago
I was just about to ask if anyone else too had the barfed up...

In forum General discussion, announcements and releases

1 month ago
What about a slot-nut with a kensington slot that is inserte...

In forum Hardware, firmware and software help

1 month ago
Are there perhaps stray filament on the heatblock that slowl...

In forum How do I print this? (Printing help)

2 months ago
I did that in the ps-start.bat i have on my directory on my ...

In forum PrusaSlicer

2 months ago
I updated my 2.3.1 to 2.3.3 yesterday (i did do a full backu...

In forum PrusaSlicer

2 months ago
Not nessecerily if the XL becomes a toolchanger. Then i thin...

In forum General discussion, announcements and releases

2 months ago
You also could add a layer of coating, expoxy or something s...

In forum How do I print this? (Printing help)

2 months ago
I'd like to see a MK4 with slightly larger buildarea, someth...

In forum General discussion, announcements and releases

2 months ago
Glad it worked out. It's sometimes the smallest annoyance th...

In forum Hardware, firmware and software help

3 months ago
Try moving the hotend to the far side, then give the cables ...

In forum Hardware, firmware and software help

3 months ago
I have only got the Bondtech extruder upgrade. I have their ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Page 1 / 11
Share: