Notifications
Clear all
BoatBuilder
BoatBuilder
Group: Registered
Joined: 2019/11/10
Eminent Member
2
What Nozzle Temp When Bed Leveling for ASA?

In forum How do I print this? (Printing help)

5 months ago
One of the advantages of the Bondtech extruder is that the p...

In forum User mods - OctoPrint, enclosures, nozzles, ...

8 months ago
I just ordered a Mosquito hot end and some boron nitride pas...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
Thank you for the numbers. I think I will do as you suggest...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
@4nthonylin Thanks. This Mini is my only printer and I’m hes...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
Has anyone used the adapter for the Mosquito hot end that is...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
I lowered the retraction first to 3,2 and later to 3,0 and e...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
@24kjames I did both the Bondtech heat break and extruder at...

In forum User mods - OctoPrint, enclosures, nozzles, ...

11 months ago
If you find a screw extractor that small (3 mm) let us know...

In forum Assembly and first prints troubleshooting

12 months ago
Pelo: There is a very long thread in the section on extrude...

In forum User mods - OctoPrint, enclosures, nozzles, ...

12 months ago
@joantabb Thank you, Joan. That is the information I was loo...

In forum Hardware, firmware and software help

12 months ago
Will Other Heater Cartridges Work on a Mini?

In forum Hardware, firmware and software help

12 months ago
No. I left the machine stock until it started having jams an...

In forum Assembly and first prints troubleshooting

1 year ago
In the Bondtech installation guide to set the filament tensi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Did you ever find settings that worked? if so can you share ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@japuSorry, but I did not see your question. It is probably...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@japuSorry, but I did not see your question. It is probably...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
There are printable fixtures on Thingiverse to cut the tubin...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
cendrizzi: I think all of my issues with the nozzles were c...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
I forgot to mention, I also replaced both the Mini’s Bowden ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
Page 1 / 3
Share: