Notifications
Clear all
herbert
herbert
Group: Registered
Joined: 2019/11/01
Trusted Member
3
For me this looks like the seem position, but I cannot reall...

In forum How do I print this? (Printing help)

6 months ago
This is the seam position, where the layer change happens

In forum How do I print this? (Printing help)

6 months ago
I would suggest you to talk to prusa support, it is a new de...

In forum Assembly and first prints troubleshooting

6 months ago
The first question which comes into my mind, did you slice i...

In forum Assembly and first prints troubleshooting

6 months ago
Das stimmt, das müsste eigentlich viel besser sein. Ich würd...

In forum How do I print this? (Printing help)

6 months ago
Guido, ich geb dir einen Tipp und da wird dir bestimmt gehol...

In forum How do I print this? (Printing help)

7 months ago
Right, should take my own advices in consideration too 🙂 , ...

In forum General discussion, announcements and releases

7 months ago
Try putting it in the freezer, perhaps you have luck. Would ...

In forum General discussion, announcements and releases

7 months ago
Just some articles on that topic

In forum General discussion, announcements and releases

7 months ago
Thanks it works now, but had nothing to do with the cache be...

In forum General discussion, announcements and releases

7 months ago
prusaprinters.org https problems

In forum General discussion, announcements and releases

7 months ago
Depending on where you live, I use 3DKordo most of the time ...

In forum General discussion, announcements and releases

7 months ago
Another tip, get down with your printing speed. Especially f...

In forum How do I print this? (Printing help)

7 months ago
Hi, I have the same "grinding" sound on my Prusa Mini if mov...

In forum Assembly and first prints troubleshooting

8 months ago
Is there a document defining the torque values ? If so I wou...

In forum General discussion, announcements and releases

8 months ago
Thanks for the detailed feedback 🙂 Thought the same by look...

In forum Hardware, firmware and software help

10 months ago
Link the two topics together 🙂 Thanks

In forum General discussion, announcements and releases

10 months ago
New Parts Release - R7 and MINI+

In forum Hardware, firmware and software help

11 months ago
As far as I understood all you need to do is opening an issu...

In forum PrusaSlicer

11 months ago
@bobstro Ah, ok, next time I keep the 3MF files, if I create...

In forum Assembly and first prints troubleshooting

11 months ago
Page 1 / 5
Share: