lippman.mark
lippman.mark
Group: Registered
Joined: 2019/10/28
Eminent Member
2
@fabio-f3 My choice was easy. The MMU failed completely. Not...

In forum Assembly and first prints troubleshooting

1 year ago
Try oiling the bearing bars. That helped my calibration a lo...

In forum Hardware, firmware and software help

1 year ago
Try oiling the bearing bars. That helped mine work much bett...

In forum Hardware, firmware and software help

1 year ago
I forgot that oiling the bearing bars helped a lot.

In forum Hardware, firmware and software help

1 year ago
Not to confident the PINDA is bad. If you replaced it you al...

In forum Hardware, firmware and software help

1 year ago
Hi, The PINDA is a fairly simple device. I believe it either...

In forum Hardware, firmware and software help

1 year ago
nicoseeleib, I had the same issue. PETG was a big problem wi...

In forum Hardware, firmware and software help

1 year ago
Don't forget to keep the bearing rods oiled. To much drag on...

In forum General discussion, announcements and releases

1 year ago
By the way, I did have to rerun calibration after oiling the...

In forum Hardware, firmware and software help

1 year ago
By the way, I did have to rerun calibration after oiling the...

In forum Hardware, firmware and software help

1 year ago
I recently had issues with calibration and after putting oil...

In forum Hardware, firmware and software help

1 year ago
I recently had issues with calibration and after putting oil...

In forum Hardware, firmware and software help

1 year ago
walbert, I had so much trouble with the MMU2S that I unplugg...

In forum Assembly and first prints troubleshooting

1 year ago
Face mask elastic strap relief band with pony tail hole, hop...

In forum Coronavirus (COVID-19)

1 year ago
I took my filament buffer out. Run directly into MMU from th...

In forum General discussion, announcements and releases

2 years ago
After you start a print and before it actually loads filamen...

In forum Assembly and first prints troubleshooting

2 years ago
Update! I took the same stl file and creat a few GCODE files...

In forum Assembly and first prints troubleshooting

2 years ago
See my post about MMU2S not loading filament to nozzle.

In forum Assembly and first prints troubleshooting

2 years ago
Which positions are you using. See my post about filament no...

In forum Assembly and first prints troubleshooting

2 years ago
MMU2S failing to load filament to nozzle

In forum Assembly and first prints troubleshooting

2 years ago
Page 1 / 2
Share:

Please Login or Register