Activity
 
Notifications
Clear all
Bodo
Bodo
Group: Registered
Joined: 2019/10/17
Estimable Member
4
Josef's blog update 13.01.20 and our MINI experience

In forum General discussion, announcements and releases

2 years ago
@kropexx, just as @crawlerin said; if you like to tinker wit...

In forum General discussion, announcements and releases

2 years ago
ABS prints fine for me, in fact I mostly print ABS. The only...

In forum General discussion, announcements and releases

2 years ago
Feedback for all expecting MINI owners: we got ours on Decem...

In forum General discussion, announcements and releases

2 years ago
@lawrence-b2, In my experience with support, email doesn't m...

In forum Hardware, firmware and software help

2 years ago
Is it used in combination with Octoprint? That's right Cleme...

In forum PrusaSlicer

2 years ago
@pingu, if you were interested in making a replacement heat ...

In forum General discussion, announcements and releases

2 years ago
@richard-h48: good work in searching for the root cause! New...

In forum Hardware, firmware and software help

2 years ago
@mattheww I emailed support as well, because the chat was cl...

In forum Hardware, firmware and software help

2 years ago
@dennis-s12, there are some errors in the stats: Every line...

In forum General discussion, announcements and releases

2 years ago
My replacement MINDA fixed the issue.

In forum Hardware, firmware and software help

2 years ago
I did some prints with the new MINDA, and the problem never ...

In forum General discussion, announcements and releases

2 years ago
Same here - although this started when I found out that my M...

In forum General discussion, announcements and releases

2 years ago
After I repaired mine (the MINDA cable) provisionally (new r...

In forum Hardware, firmware and software help

2 years ago
@pascal-l4, there's an issue reported on github that is simi...

In forum Hardware, firmware and software help

2 years ago
@milo-v, @karl-herbert, thanks guys; it now works for me. Sa...

In forum General discussion, announcements and releases

2 years ago
It's also possible to heat the bed and the nozzle separately...

In forum General discussion, announcements and releases

2 years ago
Thank you, 'jaeger - I've got this resolved:I opened the dow...

In forum PrusaSlicer

2 years ago
Thank you, works for me. The link in the branch dropdown men...

In forum PrusaSlicer

2 years ago
Result. The linked issue report above also contains a tempor...

In forum Hardware, firmware and software help

2 years ago
Page 3 / 6
Share: