Activity
 
Notifications
Clear all
mark
mark
Group: Registered
Joined: 2019/10/16
Estimable Member
4
My suggestion for cheap food dehydrator that works well for ...

In forum How do I print this? (Printing help)

4 months ago
This has worked well for me: The attached is a 1/3 segm...

In forum General discussion, announcements and releases

4 months ago
I just purchased a few precut hot end pieces from Prusa for ...

In forum Assembly and first prints troubleshooting

4 months ago
I'm going to agree on the Mini. I don't have much experience...

In forum General discussion, announcements and releases

4 months ago
The printer comes with one extra PTFE tube that goes in the ...

In forum Hardware, firmware and software help

4 months ago
A filament dryer will work way better than a drybox, especia...

In forum General discussion, announcements and releases

4 months ago
I believe this is normal if it powers up with the Z axis alr...

In forum Assembly and first prints troubleshooting

4 months ago
Well, Illustrious member @bobstro and I were able to get the...

In forum Coronavirus (COVID-19)

4 months ago
Wow, that is a long delayed answer! I forgot I asked the que...

In forum Coronavirus (COVID-19)

4 months ago
I used a Torx screwdriver from this set on the grub screws: ...

In forum General discussion, announcements and releases

4 months ago
Their chat support is pretty effective. I'm more annoyed wit...

In forum Hardware, firmware and software help

5 months ago
They shipped the one for the MK3+, same specs, shorter leads...

In forum Hardware, firmware and software help

5 months ago
I finally got it all back together, new heat block, heat bre...

In forum Hardware, firmware and software help

5 months ago
@alex-hung If you use ASA, you should have acetone on hand. ...

In forum How do I print this? (Printing help)

6 months ago
@karl-herbert Yes, in the Phoenix, Arizona area. It has reac...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
It is not so much for temperature as to exhaust the fumes ou...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
@john-doe-3 That's what I did. It's a simple piece of plexig...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
A little Acetone around the edges should be wicked under and...

In forum How do I print this? (Printing help)

6 months ago
What material are you using? Different materials ooze and sp...

In forum How do I print this? (Printing help)

6 months ago
So, what order of assembly is recommended? Install the heate...

In forum Hardware, firmware and software help

7 months ago
Page 2 / 9
Share: