Activity
 
Notifications
Clear all
mark
mark
Group: Registered
Joined: 2019/10/16
Estimable Member
4
I think the higher temperature ASA is what wore it out. I pr...

In forum General discussion, announcements and releases

2 weeks ago
In my case, with a very dirty block, the thermistor and heat...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 weeks ago
Just buy a few replacement PTFE tubes and replace them when ...

In forum General discussion, announcements and releases

2 weeks ago
A few things to try are variable layer height and modifiers....

In forum How do I print this? (Printing help)

1 month ago
What material are you using? ASA will warp. My solution is t...

In forum Assembly and first prints troubleshooting

1 month ago
As described before, I also now just consider this a mainten...

In forum General discussion, announcements and releases

1 month ago
Sorry to be the units police but this graph from @chvvkumar ...

In forum General discussion, announcements and releases

1 month ago
This type of tool worked for me. It's included in phone repa...

In forum Hardware, firmware and software help

2 months ago
Try bending the thermistor and heater wires (red wires) a li...

In forum Assembly and first prints troubleshooting

2 months ago
Can you estimate how many rolls at 260 C? i would estimate t...

In forum General discussion, announcements and releases

2 months ago
Has anyone done an independent study comparing Capricorn tub...

In forum General discussion, announcements and releases

2 months ago
I can see a difference in PETG stringing in about a day out ...

In forum How do I print this? (Printing help)

2 months ago
I put a silicone sock on the hot end. Otherwise I put it tog...

In forum How do I print this? (Printing help)

2 months ago
The biggest improvement I have seen is to dry PETG before us...

In forum How do I print this? (Printing help)

2 months ago
No, I can't. When I dried the filament for 8+ hours, there w...

In forum General discussion, announcements and releases

3 months ago
I want to point out that the Creality Dryer, as well as the ...

In forum General discussion, announcements and releases

3 months ago
You do realize that is over 27 years? If any are still worki...

In forum General discussion, announcements and releases

3 months ago
I haven't used ABS, but have used ASA. A draft shield works ...

In forum How do I print this? (Printing help)

3 months ago
We can speculate as to how many are on the development team,...

In forum General discussion, announcements and releases

4 months ago
I dry my PETG filament in the dehydrator I linked for at lea...

In forum How do I print this? (Printing help)

4 months ago
Page 1 / 9
Share: