Activity
 
Notifications
Clear all
mark
mark
Group: Registered
Joined: 2019/10/16
Estimable Member
4
This type of tool worked for me. It's included in phone repa...

In forum Hardware, firmware and software help

23 hours ago
Try bending the thermistor and heater wires (red wires) a li...

In forum Assembly and first prints troubleshooting

1 day ago
Can you estimate how many rolls at 260 C? i would estimate t...

In forum General discussion, announcements and releases

2 weeks ago
Has anyone done an independent study comparing Capricorn tub...

In forum General discussion, announcements and releases

2 weeks ago
I can see a difference in PETG stringing in about a day out ...

In forum How do I print this? (Printing help)

2 weeks ago
I put a silicone sock on the hot end. Otherwise I put it tog...

In forum How do I print this? (Printing help)

3 weeks ago
The biggest improvement I have seen is to dry PETG before us...

In forum How do I print this? (Printing help)

3 weeks ago
No, I can't. When I dried the filament for 8+ hours, there w...

In forum General discussion, announcements and releases

1 month ago
I want to point out that the Creality Dryer, as well as the ...

In forum General discussion, announcements and releases

1 month ago
You do realize that is over 27 years? If any are still worki...

In forum General discussion, announcements and releases

1 month ago
I haven't used ABS, but have used ASA. A draft shield works ...

In forum How do I print this? (Printing help)

2 months ago
We can speculate as to how many are on the development team,...

In forum General discussion, announcements and releases

2 months ago
I dry my PETG filament in the dehydrator I linked for at lea...

In forum How do I print this? (Printing help)

2 months ago
My suggestion for cheap food dehydrator that works well for ...

In forum How do I print this? (Printing help)

2 months ago
This has worked well for me: The attached is a 1/3 segm...

In forum General discussion, announcements and releases

2 months ago
I just purchased a few precut hot end pieces from Prusa for ...

In forum Assembly and first prints troubleshooting

2 months ago
I'm going to agree on the Mini. I don't have much experience...

In forum General discussion, announcements and releases

2 months ago
The printer comes with one extra PTFE tube that goes in the ...

In forum Hardware, firmware and software help

3 months ago
A filament dryer will work way better than a drybox, especia...

In forum General discussion, announcements and releases

3 months ago
I believe this is normal if it powers up with the Z axis alr...

In forum Assembly and first prints troubleshooting

3 months ago
Page 1 / 8
Share: