Activity
 
Notifications
Clear all
Tracy
Tracy
Group: Registered
Joined: 2019/10/12
Trusted Member
3
I hadn't considered Z. Good catch. These models are incredib...

In forum General discussion, announcements and releases

1 year ago
Will 3dsets models fit on a Mini

In forum General discussion, announcements and releases

1 year ago
See this thread but be careful about over correcting or you'...

In forum General discussion, announcements and releases

1 year ago
I recently started a topic about this issue. To fix it, some...

In forum General discussion, announcements and releases

1 year ago
@kiwo Yes, that's my point. You shouldn't have to calibrate ...

In forum General discussion, announcements and releases

1 year ago
The Mini is my first printer and I wouldn't recommend it. Th...

In forum General discussion, announcements and releases

1 year ago
I have just the Mini but I'm definitely obsessed. I've print...

In forum General discussion, announcements and releases

1 year ago
I'm only guessing here but I suspect the PTFE tube in the Bo...

In forum General discussion, announcements and releases

1 year ago
Even if it were to stop shrinking, the hot end will eventual...

In forum General discussion, announcements and releases

1 year ago
@stevensmith I jammed a tie wrap in there and ended up with ...

In forum Hardware, firmware and software help

2 years ago
Y axis belt has started squeaking

In forum Hardware, firmware and software help

2 years ago
That's my plan as well. People seem to be having great succe...

In forum General discussion, announcements and releases

2 years ago
Not to rain on your parade but until Prusa changes the desig...

In forum General discussion, announcements and releases

2 years ago
Successful but with extra effort that shouldn't be necessary...

In forum General discussion, announcements and releases

2 years ago
You might have better luck getting an answer in the mk3 foru...

In forum Assembly and first prints troubleshooting

2 years ago
That works! Thank you!

In forum PrusaSlicer

2 years ago
After a second failed print with this filament (Graphite Gra...

In forum General discussion, announcements and releases

2 years ago
I didn't describe that correctly. It's not under extrusion. ...

In forum General discussion, announcements and releases

2 years ago
Under extrusion with new filament

In forum General discussion, announcements and releases

2 years ago
That video shows how to use support enforcers and blockers. ...

In forum PrusaSlicer

2 years ago
Page 3 / 5
Share: