Notifications
Clear all
Sfbrain
Sfbrain
Group: Registered
Joined: 2019/09/30
Estimable Member
4
@diem Hi Diem, Thanks, i tried it today and my print is curr...

In forum How do I print this? (Printing help)

8 months ago
@diem Hi Diem, Thanks for this, but i am just a beginner and...

In forum How do I print this? (Printing help)

8 months ago
Perimeter settings in slicer ?

In forum How do I print this? (Printing help)

8 months ago
@neophyl Thanks so much, will give it a try on the next prin...

In forum How do I print this? (Printing help)

9 months ago
Print head hight in move ?

In forum How do I print this? (Printing help)

9 months ago
Had my Mini since Dec

In forum General discussion, announcements and releases

9 months ago
Developing 'NinjaFlex' profile for Mini

In forum How do I print this? (Printing help)

9 months ago
Thanks guys I worked it out ..... my router had assigned a d...

In forum General discussion, announcements and releases

10 months ago
Just the standard one issued earlier this year with a firmwa...

In forum General discussion, announcements and releases

10 months ago
Web interface has stopped ??

In forum General discussion, announcements and releases

10 months ago
Anyone printed Nylon on the Mini ?

In forum How do I print this? (Printing help)

11 months ago
Thanks guys for your thoughts. I liked the look of the Cura ...

In forum How do I print this? (Printing help)

11 months ago
Textured Surfaces ?

In forum How do I print this? (Printing help)

11 months ago
Are you using 4.0.4 firmware ? There is a slight under extru...

In forum Assembly and first prints troubleshooting

1 year ago
Anyone know when this is likely to be on 'General Release' ?...

In forum General discussion, announcements and releases

1 year ago
Way to go buddy 👍 👍 👍

In forum General discussion, announcements and releases

1 year ago
Arrhh, the 3 grub screws !! 😉 They only hold the tube insid...

In forum General discussion, announcements and releases

1 year ago
OK, i may have been unfair to many people who are only tryin...

In forum General discussion, announcements and releases

1 year ago
OK, give up with the Mini .................. Sell it to me...

In forum General discussion, announcements and releases

1 year ago
Put the filament change points in Prusaslicer before you sli...

In forum Hardware, firmware and software help

1 year ago
Page 1 / 7
Share: