Notifications
Clear all
Anachronist
Anachronist
Group: Registered
Joined: 2019/09/13
Estimable Member
4
I printed the part with a different PLA (my standby, the 2-y...

In forum How do I print this? (Printing help)

3 days ago
Update: Well, I reduced the outer perimeter speed in the sli...

In forum How do I print this? (Printing help)

3 days ago
I usually turn off elephant's foot compensation. I find that...

In forum How do I print this? (Printing help)

3 days ago
That's an idea. In fact, I can set the speed of just the out...

In forum How do I print this? (Printing help)

3 days ago
The wall angle is 45°. It's just a bevel. It doesn't get ide...

In forum How do I print this? (Printing help)

3 days ago
@jsw - that is indeed strange. Good thing you didn't have mu...

In forum How do I print this? (Printing help)

4 days ago
The textured sheet is not the problem, and I don't have a pr...

In forum How do I print this? (Printing help)

4 days ago
Well, based on what @fuchsr wrote in another thread, I raise...

In forum How do I print this? (Printing help)

4 days ago
Hm. A few minutes before I saw this, I had just posted about...

In forum How do I print this? (Printing help)

4 days ago
I was going to suggest dehydration too. I had a problem in w...

In forum How do I print this? (Printing help)

4 days ago
Outer perimeter pulls away from inside curve

In forum How do I print this? (Printing help)

4 days ago
I know this is an old thread, but I made my Rubbermaid rewin...

In forum General discussion, announcements and releases

2 weeks ago
It never occurred to me that PETG could get contaminated by ...

In forum Assembly and first prints troubleshooting

1 month ago
One thing I have noticed is a tendency for my PLA prints to ...

In forum Hardware, firmware and software help

6 months ago
Adjust rods and bearing clips? I don't see anything to adjus...

In forum Hardware, firmware and software help

6 months ago
Hey, that worked! I did the XYZ calibration over again, and ...

In forum Hardware, firmware and software help

6 months ago
@tim-2 - what I understood from the OP's long report is that...

In forum Hardware, firmware and software help

6 months ago
Then maybe I never need worry. I sometimes print multiple ti...

In forum Hardware, firmware and software help

6 months ago
@cwbullet - thanks. Mine has a gray tip. It must be the olde...

In forum Hardware, firmware and software help

6 months ago
It may be a bit of both. Those of us who mostly use PLA may ...

In forum Hardware, firmware and software help

6 months ago
Page 1 / 7
Share: