Notifications
Clear all
Paul Mullen
Paul Mullen
Group: Registered
Joined: 2019/08/16
Active Member
1
Well, you're right. They're in the model, and I have a newl...

In forum Hardware, firmware and software help

11 months ago
Reprint the MMU Pulley Body?

In forum Hardware, firmware and software help

12 months ago
Should have mentioned... Hatchbox PLA was the filament. Pru...

In forum General discussion, announcements and releases

12 months ago
One complaint. In the slicer software, I added a square sha...

In forum General discussion, announcements and releases

12 months ago
I did a test print, comparing an ironed vs un-ironed part in...

In forum General discussion, announcements and releases

12 months ago
I found a hint elsewhere to "bake" the filament. I put the ...

In forum Assembly and first prints troubleshooting

2 years ago
I haven't seen any un-installation instructions, but you can...

In forum Assembly and first prints troubleshooting

2 years ago
In the "maybe this will help" category: My problem with the...

In forum Assembly and first prints troubleshooting

2 years ago
Is there a Prusa of laser cutting devices?

In forum General discussion, announcements and releases

2 years ago
@mrslealade Maybe. There are some tips and tricks in the sl...

In forum Hardware, firmware and software help

2 years ago
Thanks for continually investing in the product. The "full r...

In forum General discussion, announcements and releases

2 years ago
I have a roll of the Primaselect that I have not been able t...

In forum General discussion, announcements and releases

2 years ago
I started to follow the procedure for Bowden length calibrat...

In forum Assembly and first prints troubleshooting

2 years ago
OK. The IR sensor is good. Quadruple checked, ('cuz double...

In forum Assembly and first prints troubleshooting

2 years ago
Do I have to preload the first filament?

In forum Assembly and first prints troubleshooting

2 years ago
Problem getting soluble filament to load, but others OK

In forum Assembly and first prints troubleshooting

2 years ago
Share: