javalabg
javalabg
Group: Registered
Joined: 2019/08/13
Active Member
1
Infill of bottom layer in spiral vase mode

In forum PrusaSlicer

9 months ago
@jsw thanks for your thoughts. Indeed, there are many factor...

In forum PrusaSlicer

9 months ago
Holes-clearance for 0.4 nozzle

In forum PrusaSlicer

9 months ago
Sorry, no sulution, I use normal mode and it's not so a big ...

In forum Hardware, firmware and software help

11 months ago
Quick tip for first layer, thin structure and very poor adhe...

In forum Print tips (Archive)

2 years ago
Stealth mode is louder than normal mode

In forum Hardware, firmware and software help

2 years ago
@tim-m30 thank you for this hint, that could be indeed the r...

In forum Hardware, firmware and software help

2 years ago
@bobstro Thank you for the info, good to know that it seems ...

In forum Hardware, firmware and software help

2 years ago
PS: I've double-checked the effect and there is definitely ...

In forum Hardware, firmware and software help

2 years ago
@tim-m30 Thanks for reply, I'm printing directly from the pa...

In forum Hardware, firmware and software help

2 years ago
PS: I'm sure the sliced gcode is OK, because after reset the...

In forum Hardware, firmware and software help

2 years ago
@tim-m30 Prusa-Slicer 2.1.0+win64 MK3S, FW 3.8.0-2684

In forum Hardware, firmware and software help

2 years ago
FW 3.8.0 printer stalling after some runs, overrrun buffers?

In forum Hardware, firmware and software help

2 years ago
@ joantabb thank you for your detailed experience, I agree w...

In forum Hardware, firmware and software help

2 years ago
I upgraded to 3.8.0 and did a bunch of calibration series, b...

In forum Hardware, firmware and software help

2 years ago
oh, thank you, that's one of the information I was looking f...

In forum Hardware, firmware and software help

2 years ago
If I do this, I loose the homogenous infill structure at lea...

In forum Hardware, firmware and software help

2 years ago
Understanding Z-value/ problem with the powdered metal sheet

In forum Hardware, firmware and software help

2 years ago
Share:

Please Login or Register