Activity
 
Matt
Matt
Group: Registered
Joined: 2019/08/12
Trusted Member
3
@raymate While you're doing that, check your hotend's PTFE t...

In forum General discussion, announcements and releases

1 month ago
@clarmrrsn It was a long weekend break for me and some of my...

In forum General discussion, announcements and releases

1 month ago
@clarmrrsn Falkirk? I was there a couple of years ago during...

In forum General discussion, announcements and releases

1 month ago
@schnoidz From someone who had no experience with Prusa prin...

In forum General discussion, announcements and releases

1 month ago
@royce All of my deliveries from Prusa have been wrapped in ...

In forum General discussion, announcements and releases

2 months ago
@cwbullet It's not going to make much of a difference. The f...

In forum General discussion, announcements and releases

2 months ago
The red light in the top of the MINDA probe goes on to indic...

In forum General discussion, announcements and releases

2 months ago
"System volume information" is a folder that sits in the roo...

In forum General discussion, announcements and releases

2 months ago
You don't, you only pay it once - Though the cost of the goo...

In forum General discussion, announcements and releases

2 months ago
I had this happen a few weeks into owning my MK3S, where aft...

In forum General discussion, announcements and releases

2 months ago
The correct behaviour is: No filament loaded --> FS lever...

In forum Hardware, firmware and software help

2 months ago
The rules now when purchasing from a non-UK seller are that ...

In forum General discussion, announcements and releases

2 months ago
I just needed some spares for my MK3S stripdown, renovation ...

In forum General discussion, announcements and releases

2 months ago
It doesn't appear to have any purpose that I can see, other ...

In forum General discussion, announcements and releases

3 months ago
Thanks for the link to the specifications - That's going int...

In forum General discussion, announcements and releases

3 months ago
The old black sensor gave zero volts when in the "off" posit...

In forum General discussion, announcements and releases

3 months ago
@baklin Assembled at the beginning of September 2019, curren...

In forum Hardware, firmware and software help

4 months ago
@christopher72 The MMU2S upgrade is fully compatible with bo...

In forum General discussion, announcements and releases

4 months ago
@cwbullet Oh, I made sure of that. Those screws are now tigh...

In forum Hardware, firmware and software help

4 months ago
There are a couple of centimetres of room in the enclosure w...

In forum Hardware, firmware and software help

4 months ago
Page 1 / 5
Share:

Please Login or Register