Notifications
Clear all
Mike Daneman
Mike Daneman
Group: Registered
Joined: 2019/08/05
Estimable Member
4
Best way to do Octoprint Pause

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Looks to me like your z height is a bit too low. Try backing...

In forum How do I print this? (Printing help)

2 years ago
How hard does it grab the paper? In my case it always moves...

In forum Assembly and first prints troubleshooting

2 years ago
I agree with you and would also like to have this feature. H...

In forum PrusaSlicer

2 years ago
@bobstro I'll give your settings a try. I've had lots of tr...

In forum How do I print this? (Printing help)

2 years ago
Another thing to try is to reduce "Z lift" (I think that's w...

In forum Hardware, firmware and software help

2 years ago
I suggest disassembling the extruder and putting some heatsi...

In forum Hardware, firmware and software help

2 years ago
Oh, forgot to mention one more thing. If it's not a problem...

In forum How do I print this? (Printing help)

2 years ago
Generally printing miniatures is one of the trickier things ...

In forum How do I print this? (Printing help)

2 years ago
@mgtarallo The fan spinning fast for a little while when you...

In forum General discussion, announcements and releases

2 years ago
Yes, this is normal.

In forum General discussion, announcements and releases

2 years ago
Thanks. I prefer Prusa slicer as well. However I found it do...

In forum General discussion, announcements and releases

2 years ago
Ok guys, I think I figured out the issue. When a new versi...

In forum General discussion, announcements and releases

2 years ago
Robert, Thanks. However, I did all of that when I setup my ...

In forum General discussion, announcements and releases

2 years ago
Thanks. I realize that this is not the Cura forum, but I fi...

In forum General discussion, announcements and releases

2 years ago
How to transfer profile from old version of cura into new ve...

In forum General discussion, announcements and releases

2 years ago
There are some high-level explanations of each setting if yo...

In forum PrusaSlicer

2 years ago
If I understand your question correctly, you’re asking what ...

In forum PrusaSlicer

2 years ago
I find that stealth mode sometimes generates resonances that...

In forum Hardware, firmware and software help

2 years ago
If getting shift even when printing from SD, then it’s likel...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Page 2 / 10
Share: