Notifications
Clear all
HeneryH
HeneryH
Group: Registered
Joined: 2019/06/05
Estimable Member
4
USA users have offered to establish in-country reseller part...

In forum General discussion, announcements and releases

4 months ago
Your filament sensor IS working. You might have a problem e...

In forum Hardware, firmware and software help

7 months ago
I'm confused now. What exactly is not working?

In forum Hardware, firmware and software help

7 months ago
If your value goes from 1 to 0 and back then your sensor is ...

In forum Hardware, firmware and software help

7 months ago
The glue stick is to make it easier to REMOVE prints not kee...

In forum Assembly and first prints troubleshooting

7 months ago
@dan-rogers I couldn't figure out why, but that would expla...

In forum Assembly and first prints troubleshooting

7 months ago
Wow, everyone seems particularly cranky today. That being sa...

In forum Assembly and first prints troubleshooting

7 months ago
There is a specific instruction sheet to remove the extruder...

In forum Hardware, firmware and software help

7 months ago
PETG does indeed warp a bit in dishwashers with heated dryin...

In forum General discussion, announcements and releases

7 months ago
I've mostly printed parts for various things around the hous...

In forum General discussion, announcements and releases

7 months ago
I'd put some effort into getting good at modeling too. Unle...

In forum General discussion, announcements and releases

8 months ago
RE: First time prints - is this normal?

In forum Assembly and first prints troubleshooting

8 months ago
Did you do a z calibration? Looks like no. There is the bu...

In forum Assembly and first prints troubleshooting

8 months ago
Sorry, wrong sub-forum. My comment applies to the MK3s

In forum Hardware, firmware and software help

8 months ago
Go into the LCD settings and turn USB Control to OFF. Counte...

In forum User mods - OctoPrint, enclosures, nozzles, ...

8 months ago
Not sure if this is related... I would check the filament de...

In forum Hardware, firmware and software help

8 months ago
Will "apt update/upgrade" pick up the 'fixes' that you are r...

In forum General discussion, announcements and releases

8 months ago
I don't understand your expectation of "official support"? ...

In forum General discussion, announcements and releases

8 months ago
Zeros are cheap enough. If it doesn't work, keep it for som...

In forum User mods - OctoPrint, enclosures, nozzles, ...

8 months ago
I use F360 personal for free. Although I had to go through ...

In forum General software discussion

9 months ago
Page 1 / 9
Share: