Forums
Members
Pedroid
Activity
 
Notifications
Clear all
Pedroid
Pedroid
Group: Registered
Joined: 2019/05/17
Eminent Member
2
Profile Activity
To be honest: I don't use this Sharp at all. I still have it...

In forum Awesome prints (Hall Of Fame)

 10 months ago
I even tried to format & reinstall the Octopi image, I g...

In forum Hardware, firmware and software help

 10 months ago
LOL, i have the same one. Spend hours with the BASIC program...

In forum Awesome prints (Hall Of Fame)

 10 months ago
Wenn das Gehäuse aus demselben Material gefertigt ist wie da...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

 12 months ago
Isopropanol will work as solvent for grease when its quality...

In forum General discussion, announcements and releases

 12 months ago
Congratulations for this awesome work! Over the last month w...

In forum General discussion, announcements and releases

 1 year ago
Have you read the excellent website of our member bobstro?

In forum General discussion, announcements and releases

 1 year ago
Alternativ-Vorschlag wenn es um wasserdicht geht: Nach dem D...

In forum Grossartige Drucke & Tipps zum Drucken

 1 year ago
Hm, are you using a VPN? I remember that i couldn't purchase...

In forum General discussion, announcements and releases

 1 year ago
I drag the slider and left click on that plus. Right clickin...

In forum PrusaSlicer

 1 year ago
Liegt dein Bauteil wirklich auf dem Druckbett? (Ich habe es ...

In forum Wie drucke ich das? (Hilfe zum Drucken)

 1 year ago
Auf dem Bild wird die Deckschicht schon von links nach recht...

In forum Wie drucke ich das? (Hilfe zum Drucken)

 1 year ago
If you activate the expert settings an additional info group...

In forum PrusaSlicer

 1 year ago
Ok. Then i'm out. Sorry.

In forum Hardware, firmware and software help

 1 year ago
Pity. Can you measure the length of the z axis rods? Should ...

In forum Hardware, firmware and software help

 1 year ago
I'm not sure about it, but ... ...in the IMG_4212 i can only...

In forum Hardware, firmware and software help

 1 year ago
My guess is that the mesh bed leveling algorithm has certain...

In forum Hardware, firmware and software help

 1 year ago
I had this when the print bed was uneven and it vanished whe...

In forum Hardware, firmware and software help

 1 year ago
Don't use the printed manual, but the online version and rea...

In forum Assembly and first prints troubleshooting

 2 years ago
I'm still guessing that the nozzle is leaking. The material ...

In forum Assembly and first prints troubleshooting

 2 years ago
Page 1 / 2
Share: