Notifications
Clear all
JacktheRipper
JacktheRipper
Group: Registered
Joined: 2019/05/03
Trusted Member
3
@neophyl Oh, I wasn't thinking of a warning in the knowledge...

In forum PrusaSlicer

6 months ago
If you have a bug to report... 3Delight...Thanks, I have don...

In forum PrusaSlicer

6 months ago
like having sequential printing enabled Well, Neophyl, I th...

In forum PrusaSlicer

6 months ago
I tried every combination of moving the layer selectors to t...

In forum PrusaSlicer

6 months ago
Well, it's back again! This time with PrusaSlicer 2.3.0. Ear...

In forum PrusaSlicer

6 months ago
So this problem has come back after working for a few months...

In forum PrusaSlicer

11 months ago
So I now have completed four storage-dispenser boxes holding...

In forum General discussion, announcements and releases

1 year ago
My printer sits on an IKEA desktop in my office, and I wante...

In forum General discussion, announcements and releases

1 year ago
30% is good and low to mid 20s is preferred. So, following t...

In forum General discussion, announcements and releases

1 year ago
Filament: How Dry Is Dry Enough???

In forum General discussion, announcements and releases

1 year ago
As I said before I suspect there is some corruption in your ...

In forum PrusaSlicer

1 year ago
So I have reinstalled PrusaSlicer 2.1.0, and confirmed that ...

In forum PrusaSlicer

1 year ago
It may be that something in your install/profiles has gotten...

In forum PrusaSlicer

1 year ago
Indeed, as I stated at the top of this thread, I was using P...

In forum PrusaSlicer

1 year ago
Right click or the padlock Yes, that's what I remember, but ...

In forum PrusaSlicer

1 year ago
Where's the Orange Ball?

In forum PrusaSlicer

1 year ago
Ok, since you have a little background in Arduino, I can spe...

In forum General discussion, announcements and releases

1 year ago
Filament Storage Cabinet with Arduino IoT Controller

In forum General discussion, announcements and releases

1 year ago
@bobstro Was this a custom project, or based off an open sou...

In forum General discussion, announcements and releases

1 year ago
RE: Oozing nozzle while doing bed leveling?

In forum General discussion, announcements and releases

1 year ago
Page 1 / 4
Share: