Notifications
Clear all
HackMonkey
HackMonkey
Group: Registered
Joined: 2019/05/02
Active Member
1
I am using the full Dragon on an MMU2. I haven't had to chan...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
I just had a massive jam on my MK3 with the Phaetus Dragon. ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

9 months ago
How is a nozzle supposed to help with bridging? Bridging is ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

9 months ago
I am guessing that maybe not all "Dragon" hot ends are the s...

In forum User mods - OctoPrint, enclosures, nozzles, ...

9 months ago
I run almost all PLA, including Inland, at 215-220C. I think...

In forum User mods - OctoPrint, enclosures, nozzles, ...

9 months ago
An additional heat sink was added directly to cool the stepp...

In forum User mods - OctoPrint, enclosures, nozzles, ...

9 months ago
Craziest thing was it was only a handful of filaments that r...

In forum User mods - OctoPrint, enclosures, nozzles, ...

9 months ago
I have noticed a marked reduction in heat creep after swappi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

9 months ago
It would have been fine, had curiosity not got me, and I jus...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
My Phaetus unit didn't seem to have any thread locker on it,...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
I printed a new shroud in ABS, doesn't need a fan to print! ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
Swapped on a Phaetus Dragon today. I jammed up the V6 so bad...

In forum User mods - OctoPrint, enclosures, nozzles, ...

10 months ago
That is why I only keep the nylon, and super sensitive stuff...

In forum General discussion, announcements and releases

10 months ago
Lower is better. I typically can get my dry box down to abou...

In forum General discussion, announcements and releases

10 months ago
That is an interesting approach I wasn't aware of it. Howeve...

In forum Hardware, firmware and software help

3 years ago
Possible to reuse previous mesh, and not level every print?

In forum Hardware, firmware and software help

3 years ago
Share: